SoundCraft 1601E manual Effect Start Sync, Applying the BPM-FX

Page 35

EFFECT START SYNC

The effect sync (LFO waveform) will re-trigger every time any of the following occurs:

the BPM FX Mix fader is moved away from the [original] position, either of the BPM FX switches is moved to its [on] position,

or

the selected effect button (1-5) is pressed.

Applying the BPM-FX

If the BPM-FX switch on either of the input channels is set to the ON position, the effects will be applied to that input channel.

If both switches are set to ON, the bpm-fx effects will be applied to the master output.

35

Image 35

Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow Recommended Headphone Impedance = 200 Ohms Safety Symbol GuideHeadphones Safety Warning TIPBPM Effects IntroductionPage Mains Installation InstallationGeneral Precautions Shielding Initial Wiring ConsiderationsAudio Wiring Working Safely with Sound Points to RememberEnvironmental Considerations Inspection and InstallationPowering Unpacking and InspectionConnecting to a Typical Sound System Replacing The Faders Making Adjustments and Fitting SparesSetting The Pre-trim Pads Changing The Orientation Of The Phono/Line SwitchesPage TOP Panel DescriptionBPM FX MIX Fader BPM FX Section seeBalanced Booth Outputs -XLR Connectors Rear Connector PanelBalanced Master Outputs -XLR Connectors EQ CUT -Rotary Front PanelMIC / Line Input Combi -XLR ConnectorOperation Getting StartedMIC Insert Socket rearcon Level ControlEQ -LOW Control EQ -HIGH ControlPRE-TRIM Pads Input Selector SwitchesClip Indicators MID EQ Channel Volume FadersTrim HI EQSend -SELECT FX Send & Return / AUXSend -LEVEL Record OUTReturn / AUX -LEVEL Clip IndicatorFX ON/OFF Switch FX SEND/RETURN RE-CONFIGURATIONMaster / Booth Output Fader Curve FaderExciter Headphone Sockets Headphone MonitorLevel MASTER/CUE SelectMonitor Operating Criteria Bank ModeBeats Indicator BPM FX ModuleY Controls TAP/CLEARIsolator BPM FX MIX ON-OFF switchesActivating the Effects Setting UPQuick Start ConnectionsTAP -Tempo Edit OperationBPM Range TAP/CLEAR ButtonApplying the BPM-FX Effect Start SyncRotary Encoder Effect ControlsMIX Fader Band Isolator Single Mode SINGLE/MULTI Mode OperationMode Bank select Program Edit and Recall Multi ModeAdditional speed settings for FILTER/FLANGER/PANNER Frequency EffectsFilter SUB-MENU Repeats Y DelaySpeed WAY Split Y PANSPS Slope Y CutterDepth X mark space ratio Depth Y FlangeResonance is factory set @ 75% Hints & Tips PRE-SET Voice ListBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Post after the channel fader GlossaryEqualising the system to notch out the offending frequencies Riaa