SoundCraft 1601E manual Contents

Page 3

Contents

IMPORTANT SAFETY INSTRUCTIONS	4
SAFETY SYMBOL GUIDE	6

INTRODUCTION	7
BPM EFFECTS	7
INSTALLATION	9
GENERAL PRECAUTIONS	9
MAINS INSTALLATION	9
INITIAL WIRING CONSIDERATIONS	10
AUDIO WIRING	10
SHIELDING	10
WORKING SAFELY WITH SOUND	10
POINTS TO REMEMBER	11
INSPECTION AND INSTALLATION	12
CONNECTING TO A TYPICAL SOUND SYSTEM	13
MAKING ADJUSTMENTS AND FITTING SPARES	14
DESCRIPTION	16
TOP PANEL	16
REAR CONNECTOR PANEL	18
FRONT PANEL	19
OPERATION	20
GETTING STARTED	20
MIC / LINE INPUT	20
CHANNELS 1 & 2	22
FX SEND & RETURN / AUX	24
MASTER / BOOTH OUTPUT	26
X-FADER	27
HEADPHONE MONITOR	28
THE BPM FX MODULE	30
OPERATING CRITERIA	30
TOP PANEL CONTROLS	30
QUICK START	33
OPERATION	34
EFFECT CONTROLS	36
SINGLE/MULTI MODE OPERATION	38
THE EFFECTS	40
PRE-SET VOICE LIST	46
HINTS & TIPS	46
BLOCK DIAGRAM	47
CONNECTING LEADS	48
TROUBLESHOOTING	49
SPECIFICATIONS	50
WARRANTY	51
GLOSSARY	52

3

Image 3

Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow Recommended Headphone Impedance = 200 Ohms Safety Symbol GuideHeadphones Safety Warning TIPBPM Effects IntroductionPage Installation General PrecautionsMains Installation Initial Wiring Considerations Audio WiringShielding Working Safely with Sound Points to RememberEnvironmental Considerations Inspection and InstallationPowering Unpacking and InspectionConnecting to a Typical Sound System Replacing The Faders Making Adjustments and Fitting SparesSetting The Pre-trim Pads Changing The Orientation Of The Phono/Line SwitchesPage TOP Panel DescriptionBPM FX MIX Fader BPM FX Section seeRear Connector Panel Balanced Master Outputs -XLR ConnectorsBalanced Booth Outputs -XLR Connectors EQ CUT -Rotary Front PanelMIC / Line Input Combi -XLR ConnectorOperation Getting StartedMIC Insert Socket rearcon Level ControlEQ -LOW Control EQ -HIGH ControlInput Selector Switches Clip IndicatorsPRE-TRIM Pads MID EQ Channel Volume FadersTrim HI EQSend -SELECT FX Send & Return / AUXSend -LEVEL Record OUTReturn / AUX -LEVEL Clip IndicatorFX ON/OFF Switch FX SEND/RETURN RE-CONFIGURATIONMaster / Booth Output Fader ExciterFader Curve Headphone Sockets Headphone MonitorLevel MASTER/CUE SelectMonitor Operating Criteria Bank ModeBeats Indicator BPM FX ModuleTAP/CLEAR IsolatorY Controls BPM FX MIX ON-OFF switchesActivating the Effects Setting UPQuick Start ConnectionsTAP -Tempo Edit OperationBPM Range TAP/CLEAR ButtonApplying the BPM-FX Effect Start SyncEffect Controls MIX FaderRotary Encoder Band Isolator SINGLE/MULTI Mode Operation Mode Bank selectSingle Mode Multi Mode Additional speed settings for FILTER/FLANGER/PANNERProgram Edit and Recall Effects FilterFrequency SUB-MENU Delay SpeedRepeats Y PAN SPSWAY Split Y Cutter Depth X mark space ratioSlope Y Flange Resonance is factory set @ 75%Depth Y Hints & Tips PRE-SET Voice ListBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Post after the channel fader GlossaryEqualising the system to notch out the offending frequencies Riaa