Aviom A-16R, A-16CS manual Data Storage, Midi

Page 66

Aviom A-16R and A-16CS User Guide

The A-16R will respond to the following MIDI messages:

MIDI

Controller

Result:

Message:

or Program

 

 

Value:

 

Program

0-15

Recalls Presets 1-16

Change:

 

 

Program

16-31

Selects Channels 1-16

Change:

 

 

Controller 7:

0-127

Mapped to Current

 

 

Channel Volume (min. to

 

 

max.)

Controller 10:

0-127

Mapped to Current

 

 

Channel Pan (left to right)

Controller 104:

any

Mutes the Current Channel

Controller 105:

any

Unmutes the Current

 

 

Channel

Note that MIDI Controller 10 will be mapped to control Linked Channel Spread if STEREO LINK is active for the currently selected channel. (This is set from the front panel of the A-16T, AN-16/i-M, or AN-16/i Input Modules, or from the DIP switches on the Y1 A-Net card.) In that scenario, the stereo spread will increase as the controller value increases. If a Group is active, MIDI pan will be ignored, since Group panning must be set per channel when the Group is being configured.

Some points to remember about MIDI:

The A-16R will only respond to MIDI control messages that are sent on the MIDI channel that the A-16R is assigned to.

The A-16R can only listen to MIDI when in Lo- cal/MIDI mode. This means that it is not possible to use MIDI automation while using an A-16CS Control Surface.

A-16R front panel controls are not sent out via MIDI; the MIDI Out jack on the A-16R is only used for SysEx data dumps of Preset files.

Data Storage

Two types of MIDI SysEx data can be generated by the A-16R, single preset files and files that contain all sixteen user Presets.

56

Image 66
Contents 16R Personal Mixer 16CS Control Surface User GuideAviom, Inc Page Warranty Information Read this First Aviom, Inc. Limited Warranty Table of Contents Table of Contents Midi I/OMidi Page Features WelcomeConventions Used in this Document Optional Remote ControlUsing Personal Mixers Button PressesMaster Volume Control 16R Front Panel 16R Components left side16R Components right side 16R Rear Panel Audio Connections16R Midi and Data Connections 16CS Components Left Side16CS Right Side Package Contents AC Line ConditioningInstalling the A-16R in a Rack Channel LabelsMixer Label Strip What is Category 5? Cables Used in the Aviom SystemCategory 6 Cables Cable Lengths Up to 500 feet of Cat-5 cable can be used to connectInfinite number A-Net components About A-Net Power Supplies Power Supply PolarityCleaning Maintenance System Setup AC Power ConnectionSystem Interconnections Audio Connections Inputs Audio Connections OutputsLabeling the Channels Powering Up Basic NavigationPreparing to Make a Mix Set the Channel Volume MixingSet the Pan Location Saving Your New Preset What Gets SavedInformation Not Saved With a Preset Net Connection Options Parallel A-Net routing using an A-16D A-Net DistributorSystem Navigation Series ConnectionMixing 16D ProA-16R Personal Mixer Operational ModesGlobal Controls the Master Section Tone ControlsMaster Volume Button BehaviorsMaking Changes to Channel Settings Before You Start Editing Volume and Pan Control Pan and Volume ControlsPan LEDs Linking Channels Spread ControlSpread turns this Single-Channel Solo Held Solo ModeSolo Modes Into this, for exampleMuting a Channel Creating Groups Creating Additional Groups Changing Channel Volumes Within a Group Making Changes to a GroupRemoving Channels From a Group Muting Groups Net Connectors DC Power InputAudio Outputs Stereo Operation Mono OperationBalanced Inserts Signal Flow MixControl Midi I/O Net In and OutAviom A-16R and A-16CS User Guide Overview A-16CS Front PanelGlobal Controls Master Volume Button Behaviors Changing Channel Settings Channel Volume and Pan ControlAll Volumes Zero Muting a Channel Recalling a Preset From the A-16CS Saving a Mix From the A-16CSDisplay the Current Preset Number A-16CS Rear PanelFootswitch Jack Midi Midi JacksMidi Out 16R Midi Base ChannelMidi Midi ThruMidi Automation Data Storage MidiSaving Presets Save One Mix Preset via MidiSaving All Mix Presets via Midi Loading One Preset via Midi Loading . via MidiLoading an All Preset File via Midi Exit Midi ModePage Problem Can’t change Presets TroubleshootingProblem No audio from the Personal Mixer outputs Problem Can’t hear a Channel that is part of a GroupProblem The A-Net LED is on, but there is no sound Problem Don’t know if a Preset was saved Problem In Group mode, can’t select a new ChannelSpecifications 16R Personal Mixer16CS Control Surface Midi Implementation Chart Midi System Exclusive Implementation Version 1.00 for Aviom A-16RMidi System Exclusive Packet Head Message Data Format Midi All Presets Message Type = 00H Midi Current Preset Message Type = 01H Presetsmsg 1111 F7H End of Exclusive 0111 Valid preset Range Midi Current Preset Detail 1111 F7H End of Exclusive 0111 Symbols IndexIndex LAN Muting a Channel 33 Program Change Muting Groups XLR Aviom Warranty Registration