Keyboard Stand Assembly
CAUTION
•Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below.
•Assembly should be carried out by at least two per- sons.
•Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
•Be sure to tighten up all screws upon completing assembly of each unit.
•To disassemble, reverse the assembly sequence given below.
Have a
Remove the following parts from the package.
Assembly Parts
6 ⋅ 45 mm long screws ⋅4 1
Preparing the rear panels
When the package is shipped from the factory, the rear panels are secured to the wooden fixing pads with screws. Before you can start assembling the rear panels, you must first remove them from the fixing pads.
Removing the panels:
Stack two packing pads (included in the packing box with the rear panels) under the rear panels, then remove the screws as shown in the illustra- tions.
CAUTION
•Do not use screws fixing rear panels to assem- ble the Clavinova.
Rear panel (center) | Fixing pad |
Stack two packing pads.
Rear panels (left, right)
ENGLISH
Cord holders ⋅ 2
6 ⋅ 14 mm short screws ⋅12 2
| 1 Insert the rear panel (center). |
| Position the rear panel (center) so that the word |
| “Clavinova” faces the front (keyboard side). Then |
Rear panel (left) Rear panel (center) Rear panel (right) | insert the projections on the panel into the holes |
| on top of the unit, as shown in the illustration. |
Main unit |
|
AC power cord
keyboard stand stabilizers: 2 pieces
Included in the packing pads.
CAUTION
•When the rear panel (center) is inserted in the main unit, do not apply pressure to the rear panel (center) from the front or rear. Doing so may dam- age the projections of the rear panel (center), allowing it to fall or be damaged.