Yamaha CLP-F01 owner manual FCC Information U.S.A

Page 78

FCC INFORMATION (U.S.A.)

1.IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instruc- tions contained in this manual, meets FCC require- ments. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2.IMPORTANT: When connecting this product to acces- sories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Fail- ure to follow instructions could void your FCC authori- zation to use this product in the USA.

3.NOTE: This product has been tested and found to com- ply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/ uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of

other electronic devices. Compliance with FCC regula- tions does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfac- tory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corpo- ration of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.(class B)

IMPORTANT NOTICE FOR THE UNITED KINGDOM

Connecting the Plug and Cord

IMPORTANT. The wires in this mains lead are coloured in accordance with the following code:

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this appa- ratus may not correspond with the coloured makings iden- tifying the terminals in your plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured

BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth ter- minal of the three pin plug.

(2 wires)

This applies only to products distributed by Yamaha-Kemble Music (U.K.) Ltd.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLEC-

TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE

LA FICHE DANS LA BORNE CORRESPONDANTE DE LA

PRISE ET POUSSER JUSQU’AU FOND.

(polarity)

This applies only to products distributed by Yamaha Canada Music Ltd.

Ceci ne s’applique qu’aux produits distribués par Yamaha Canada Musique Ltée.

Image 78
Contents CLP-F01 Special Message Section Precautions Connections Reference TrademarksIntroduction AppendixTable of Contents Application Index Bench may be included or optional, depending on your locale AccessoriesTuning TransportingFeatures TransposeTo open the key cover Before Using the ClavinovaKey Cover To close the key coverMusic Rest To position the music rest for useTo replace the music rest Turn the power on Turning the Power OnConnect the power cord Power indicatorSetting the Volume Using Headphones optionUsing the Speaker Switch Memo Clavinova’s various functions Panel Controls and TerminalsConnectors Panel Controls and TerminalsTop panel Display Listening to the Demonstration Tunes Play any of the 50 preset songs Listening to 50 Piano Preset SongsEngage Preset Song mode Stop playbackTurn off the playback part you wish to practice Exit from Preset Song modeHow to use the practice functions Start playback and playingLeft Pedal Start/Stop Repeat for 50 Preset Songs Will appear on the disSelecting Voices Using the PedalsSelecting & Playing Voices Damper Right PedalNormal setting Sostenuto Center PedalSoft Left Pedal Depth 0 no effect Adjusting Reverb DepthAdjusting Effect Depth Depth 0 no effect Depth 20 maximum effect depthChanging the volume when Fixed is selected Touch Sensitivity TouchTransposition Transpose TransposeCombining Two Voices Dual mode Engage Dual modeExit Dual mode and return to normal play mode Engage Split mode SplitSelect a voice for the right hand Exit Split mode and return to normal play modePress the Split button again so that its indicator goes out Select a voice for the left handAdjusting the time signature Using the MetronomeAdjusting the tempo Start the metronomeSelect a song for recording Make all the initial settingsRecording Your Performance Recording vs. SavingStart recording Engage Record modeSelect the record track Stop recordingRe-recording Track Recording to TrackIndividual Tracks Voice selectionEntire Song You can change the following initial settings Change the settings via the panel controlsPress the REC button to exit Record mode Playing Back a Song Midi connectorsPlaying Back Recorded Songs Select the desired songAssigning the START/STOP function to the left pedal Useful Playback FunctionsTurning track playback on and off SynchroDetailed Settings Function Parameter ListSelect a function Basic Procedure in Function ModeEngage Function mode Use the -/NO +/YES buttonsDo the following when you finish using the func- tion Operation Example 1 F1. Fine tuning of the pitchOperation Example 2 F3.1 Dual Balance Display Value Setting rangeAbout Each Function Hz HertzPythagorean EqualPureMajor/PureMinor MeanToneDual Detune ResetSub-mode Dual Balance Voice 1 Octave Shift Voice 2 Octave ShiftRight Voice Octave Shift Left Voice Octave Shift Sub-mode Split PointSplit Balance Right Voice Effect Depth Left Voice Effect DepthSoft Pedal Effect Depth Sub-mode Left Pedal ModeKeyoff Sample Volume Sustain Sample DepthF6. Metronome Volume Sub-mode Midi Transmit Channel SelectionLocal Control ON/OFF Setting range ON/OFF Normal setting onMidi Receive Channel Selection Program Change ON/OFFPanel/Status Transmit ProcedureMidi Transmit Transpose Bulk Data DumpSetting range ON/OFF Normal setting OFF all groups Sub-mode Voice Midi Tuning OthersFactory Preset Recall Description of sub-modes VoiceAbout Midi Midi connectorsTo Host connector Midi cablesConnectors ConnectionsAUX in R, L/L+R jacks AUX in L/L+R jack or AUX OUT L/L+R jackConnecting a Personal Computer On the power to the computer first, then to the ClavinovaType of serial cables and connection pin assignments ConnectionClavinova Host Select switch setting Set the Clavinova Host Select switch to MidiConnection Computer Troubleshooting Problem Possible Cause and SolutionKeyboard Stand Assembly Removing the panelsInsert the rear panel center Fasten the rear panels securely Install the rear panels left and rightVoltage Selector Attach the fall-prevention bracketMove the Clavinova to an appropriate location After completing the assembly, please check the followingReview the assembly procedure and correct any errors Check the connectionPreset Voice List Voice Name Stereo Touch Dynamic Key-Off Voice DescriptionsWood Bass Voice Name Title Composer Demo Song ListPiano Voice Demo Description Voice Name Piano Voice DemoIndex 16, 29 Practicing a One-Hand Part Using 50 Preset Songs......20Soft Pedal 16, 24 Start/Stop playbackAppendix Backup Group Function number Default Backup GroupFunction CLP-F01Appendix Panel Data Contents Midi Master VolumePanel Data Transmit General Midi Mode On Data format F0H 7EH XnH 09H 01H F7HEffect Midi Map Midi Parameter Change table EffectMidi Parameter Change table Multi Part Midi Implementation Chart ON/OFF Memo Memo Please Keep this Manual FCC Information U.S.A North America Clavinova Web site English only Yamaha Manual Library