OWNER’S MANUAL
OPERATING
FIREPLACE
Continued
REMOTE
OPERATION
Follow instructions included with the re- mote control.
NOTICE: You must light the pilot before using the
1. After lighting, let pilot flame burn for |
about one minute. Turn gas control |
knob on the control valve to ON posi- |
tion. Turn variable control knob any- |
where between HI and LO. Slide the |
selector switch to the REMOTE po- |
OPERATING
BLOWER
Locate the blower controls by opening the lower louver panel on the fireplace. Blower controls are located on the left side of the switch bracket to the left just inside the louver panel.
The GA3700 manual blower has an ON setting and an OFF setting. The blower will only run when the switch is in the ON position. In the OFF position, the blower will not operate.
The blower helps distribute heated air from the fireplace. Periodically check the louvers of the firebox and remove any dust, dirt, or other obstructions that will hinder the flow of air.
Blower Control Knob
INSPECTING
BURNERS
Check pilot flame pattern and burner flame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper flame height. Alterations may have occurred during shipping and handling. Call a qualified service person to readjust the pilot if necessary.
The height of the thermopile must be 3/8" to 1/2" above the pilot flame as shown in Figure
58.The thermocouple must be at a height of about 1/8" above the pilot flame. The flame from the pilot burner must extend beyond both the thermocouple and thermopile.
If your pilot assembly does not meet these requirements:
sition. Note: The burner may light if |
when selector switch was last turned |
off. You can now turn the burners on |
and off with the |
trol unit. |
IMPORTANT: Do not leave the se- |
lector switch in the REMOTE posi- |
tion when the pilot is not lit. This will |
drain the battery. |
OFF
ON
REMOTE
OFF
ON
Selector Switch in Remote Position
N
O
T | F | O |
O |
| |
F |
| |
LIP |
|
|
Gas Control
Knob in On
Position
•turn fireplace off (seeTo Turn Off Gas to Appliance, page 26)
•seeTroubleshooting, pages 31 through 34
Thermopile
3/8" to 1/2"
Pilot Burner
IMPORTANT: Be sure to press the |
ON/OFF button on the |
mote control unit for up to 3 seconds |
to assure proper operation. |
2. Press the ON/OFF button to turn the |
burners on and off. When turning |
burners off, the pilot will remain lit. |
IMPORTANT: To turn the pilot off, |
manually turn the gas control knob |
on the heater to the OFF position. |
Figure 57 - Setting the Selector Switch and Gas Control Knob for Remote Operation
1/8"
Thermocouple
Piezo
Ignitor
Figure 58 - Pilot Assembly
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating. Flame patterns will be different from unit to unit and will vary depending on installation type and weather conditions.
If the vent configuration is installed incor- rectly, the flames will lift or "ghost". This can be dangerous. Inspect the flames after installation to ensure proper installation and performance.
Continued
106497 | 27 |