Desa (V)T36NA Replacement Parts, Service Hints, Technical Service, Specifications, Accessories

Page 36

Replacement Parts

Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.

Parts Under Warranty

Contact authorized retailers of this product. If they can not supply original replacement part(s), call DESA’s Customer Service Department at 1-866-672-6040.

When calling DESA, have ready

your name

your address

model and serial numbers of your fireplace

how fireplace was malfunctioning

type of gas used (propane/LP or natural gas)

purchase date

Usually, we will ask you to return the part to the factory.

Parts Not Under Warranty Contact authorized retailers of this product. If they can not supply original replacement part(s), call DESA at 1-866-672-6040 for referral information. When calling DESA, have ready

model number of your fireplace

the replacement part number

Service Hints

When Gas Pressure Is Too Low

• pilot will not stay lit

• burners will have delayed ignition

• fireplace will not produce specified heat

• propane/LP gas supply might be low (propane/ LP units only)

You may feel your gas pressure is too low. If so, contact your local gas supplier.

Technical Service

You may have further questions about installation, operation, or troubleshooting. If so, contact DESA’s Customer Service Department at 1-866-672-6040. When calling please have your model and serial numbers of your heater ready.

You can also visit DESA’s technical service web site at www.desatech.com.

Specifications

(V)T36NA Series and CTDV36NRA

• Rating: 15,400/22,000 Btu/Hr

• Gas Type: Natural

• Ignition: Piezo

• Manifold Pressure: 3.5" W.C.

• Minimum Inlet Supply Pressure: 5.5" W.C.

• Dimensions (Actual size of firebox. Measure- ments do no include nailing flanges or stand- offs): 36" x 41" x 21 1/8"

(V)T36PA Series

• Rating: 14,000/20,000 Btu/Hr

• Gas Type: Propane/LP

• Ignition: Piezo

• Manifold Pressure: 10.0" W.C.

• Minimum Inlet Supply Pressure: 11.0" W.C.

• Dimensions (Actual size of firebox. Measure- ments do no include nailing flanges or stand- offs): 36" x 41" x 21 1/8"

Accessories

NOTICE: All accessories may not be available for all fireplace models.

Purchase these fireplace accessories from your local retailer. If they can not supply these acces- sories, call DESA at 1-866-672-6040. for informa- tion. You can also write to the address listed on the back page of this manual.

Brick Liner KIT

(Not Shown)

BL36DA - Textured Refractory

BL36DSA - Standard Refractory BL36DHA - Textured Refractory, Herringbone BL36DHSA - Standard Refractory, Herringbone This brick liner adds a touch of style to your direct- vent fireplace. Complete installation and operation instructions included in this manual.

Flexible gas Line connector GA5081

(Not Shown) For all models.

Propane/natural gas conversion kit

(Not Shown) Included with CTDV36

Model

PCDM-36TA- Propane/LP Gas

NCDM-36TA- Natural Gas

36

www.desatech.com

111250-01E

Image 36
Contents What to do if YOU Smell GAS Table of Contents Safety InformationSafety Information Product Features Local CodesProduct Identification High traffic areasPre-Installation Preparation Location and space requirementsThis fireplace does not require electricity to operate Proper clearances must be maintainedClearances Framing and finishingFront Top of Standoffs Vent See venting Venting clearancesLocation of Termination Cap Balcony with Perpendicular Side WallVenting Installation Instructions Installation PrecautionsInstallation Planning Installing Horizontal Vent Cap Noncombustible Exterior Ground Floor Installation 32 minSnorkel Termination Installation Recommended Applications Corner ground floor installationHorizontal System Installation Using TWO 90 Elbows Installation for vertical termination Flat Ceiling InstallationConnect a section of pipe and extend up through the hole Twist-lock the vent cap onto the last section of vent pipe High Altitude Installation Vertical VentingDesa Venting Accessories Desa ElbowsDesa Terminations Number DescriptionFireplace Installation Installing optional blower accessoriesModel BK Installation Check GAS TypeModel BKT Installation Plug in blower power cord to duplex outletInstalling Gas Piping to Fireplace Location Blower Wiring DiagramInstallation Items Needed Connecting Fireplace to GAS Supply Checking GAS ConnectionsPressure Testing Fireplace Gas Connections Test Pressures Equal To or Less Than Psig 3.5 kPaInstalling optional wall mount switch GWMS2 Installing Remote ReceiverOpen bottom louver and locate the switch Cleaning Glass Door Removing/Replacing Glass DoorRemoving Louver Panels Removing Glass DoorInstalling logs, lava rock and glowing embers Close top and bottom louversInstalling Log No For your safety Read before lighting Operating FireplaceLighting Instructions To Turn OFF GAS To ApplianceManual Lighting Procedure Optional Hand-HeldOn/Off Series Models HRC100 and HRC101 Remote OperationOperating optional blower accessory Safety FeaturesAuto Shutoff Feature Operating optional GWMT1 Wall Mounted ThermostatCleaning Maintenance Pilot AssemblyInspecting Burners Burner Flame PatternPilot and burners LogsVenting system Troubleshooting Observed Problem Possible Cause Remedy Mocouple to cool, causing Problem could be caused by Replace pilot assembly Burner orifice clogged Clean burner see Cleaning Is lit After pilot lights, keep gasWhen burner is lit Dirty or partially clogged 3. Clean burner see CleaningOr shut off Service person Remote does not function Tery power is lowGas leak. See Warning Statement aboveReplacement Parts Service HintsTechnical Service SpecificationsWall mounted on/off switch gwms2 Not Shown Face/Louver Panel kitRolled Louver Trim kit Deflection hoodIllustrated Parts Breakdown Rear Refractory Brick Panel Left Refractory Brick PanelIllustrated Parts Breakdown 11102 111250-01E 111250-01E Warranty Information Keep this WarrantyLimited Warranty DIRECT-VENT Fireplace