Desa VDCFTNA installation manual Optional Hand-Held, Remote Operation, On/Off Series Model HRC100

Page 25

OPERATING FIREPLACE

Continued

optional Hand-Held

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 40). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 23.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to

ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 43). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand- held remote control unit.

IMPORTANT:Do not leave the selectorswitch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

FlameControl

Adjustment Knob Knob

Selector Switch in Remote Position (Optional Remote Control)

Figure 43 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

On/Off Series (Model HRC100)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 44).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Control

Indicator Button

Light

Figure 44 - On/Off Hand-Held Remote

Control Unit

Thermostat Series (Model HRC200)

The hand-held remote can be operated using either the manual mode (MANU) or thermo- static mode (AUTO) (see Figure 45). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Manual Mode

1. Press the POWER and LOCK buttons togeth- er to turn on the hand-held remote control.

2. Press the MANU button to turn on the fireplace.

3. Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by press- ing the TEMP + or - buttons.

4. Press the POWER and LOCK buttons together to turn off the fireplace.

 

 

 

 

Digital

Locks

 

AUTO

Display

ROOM

 

SET

Shows

System to

TEMP

 

TEMP

 

 

 

Temperature

Prevent

 

 

 

 

TEMP

 

and Settings

Accidental

LOCK

POWER

Ignition

 

 

 

 

Turns

MANU

ºC/ºF

AUTO

 

Burners

 

 

 

Turns

 

 

 

Hand-Held

On or

 

 

 

 

 

 

Remote On

Off

 

 

 

 

 

 

or Off and

 

 

 

 

Increases

 

 

 

Allows You

 

 

 

to Choose

or Decreases

 

 

 

°C/°F

 

the Manual

Room

Selects

Setting

Temperature

Mode

AUTO

 

in AUTO Mode

Button

Mode

 

Figure 45 - Thermostat Hand-Held

Remote Control Unit

113133-01C

www.desatech.com

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Thermostat Models Vdcftna and Vdcftpa Remote-Ready Models Shown with Optional Cabinet Mantel/Hearth Base AccessoryVdcfrpa and Vdcfrna Table of Contents Safety Information Safety Information Product Features Optional Remote Control AccessoriesProduct Identification Local CodesAir for Combustion Ventilation Hood AssemblyTools Required Phillips screwdriver Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Fireplace Location Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Check GAS Type InstallationInstallation Items InstallationFireplace Clearances Fireplace pilot and burner must be at least 18 above floorIf you have not installed hood, follow instruc- tions on Built-In Fireplace InstallationRoute flexible gas line through access hole in hearth base Optional Mantel InstallationCheck all gas connections for leaks. See Installing Optional Blower Accessory GA3450TARemoving Upper Louver Remove 4 screws from upper louver see . Save these screws Installing Blower AccessoryOpen lower louver door by swinging door down see Figure Extension Cord For Built-In InstallationExternal Regulator With Vent Pointing Down Connecting to GAS SupplyInstallation Items Needed Connecting equipment shutoff valve to heater controlChecking GAS Connections Equipment Shutoff Valve Pressure Testing Fireplace Gas ConnectionsInstalling 9-Volt Battery in Hand-Held Remote Control Unit Installing ReceiverRemove battery cover on back of remote control unit Replace battery cover onto remote control unitRemove jumper wire from control valve see , Optional Wall Switch GWMS2 Remote-Ready Models OnlyFor Your Safety Read Before Lighting Installing LOG SET and ScreenOperating Fireplace Lighting InstructionsOperating Fireplace Manual Lighting ProcedureTo Turn OFF GAS To Appliance Thermostat Control OperationOperating Blower AUTO/OFF/ON Blower SwitchDepress control knob and light pilot with match Remote Operation Optional Hand-HeldOn/Off Series Model HRC100 Thermostat Series Model HRC200Safety Features Optional GWMS2 Wall Mounted SwitchAuto Shutoff Feature Key Pad Lock FeatureInspecting Burners Cleaning MaintenancePilot Flame Pattern Burner Flame PatternWiring Diagram Cleaning MaintenanceLOG Set CabinetObserved Problem Possible Cause Remedy TroubleshootingTroubleshooting Mote-Ready Models Only Power is low When heated, vapors fromSlight smoke or odor during Initial operation Processes and log curingGas leak. See Warning VDCFTPA, Vdcfrpa SpecificationsFirebox Models VDC Illustrated Parts BreakdownParts List Thermostat Models Illustrated Parts BreakdownVdcftpa and Vdcftna Parts List Vdcfrna and Vdcfrpa REMOTE-READY ModelsKEY Equipment Shutoff Valve GA5010 AccessoriesTHERMOSTAT-CONTROLLED Blower KIT GA3450T WALL-MOUNT ON/OFF Switch AccessoriesReceiver and HAND-HELD Thermostat Remote Control KIT HRC200 Receiver and HAND-HELD Remote Control KIT HRC100Service Hints Replacement PartsTechnical Service Parts Under Warranty113133-01C Keep this Warranty Warranty InformationLimited Warranty VENT-FREE Compact Classic Hearth
Top Page Image Contents