Desa VDCFTNA installation manual Accessories, Equipment Shutoff Valve GA5010

Page 40

Accessories

NOTICE: All accessories may not be available for all fireplace models.

Purchase these fireplace accessories from your lo- cal dealer. If they can not supply these accessories, call DESA Heating Products at 1-866-672-6040 for referral information. You can also write to the address listed on the back page of this manual.

EQUIPMENT SHUTOFF VALVE GA5010

For all models. Equipment shutoff valve with 1/8" NPT tap. Fits 1/2" NPT pipe.

Perimeter TRIM KIT - GA6095

For all models. Optional four-sided perimeter trim kit for recessed built-in installations (when unit is raised off of the floor). Provides a finished appear- ance by covering rough edges of wall opening.

Perimeter Trim Kit

(Not Shown)

GA6094 - Polished Brass

GAB6094 - Black

GAP6094 - Platinum

For all models. Optional three-sided perimeter trim kit for custom and recessed installations (when unit is on the floor). Provides a finished ap- pearance by covering rough edges of wall opening. Black trim included with all mantels.

Extruded Louver Kit (Not Shown)

GA9092 - Polished Brass

GAP9092 - Platinum

For all models. Optional extruded louver. Kit contains 2 louvers.

THERMOSTAT-CONTROLLED BLOWER KIT - GA3450T

For all models. Provides better heat distribution. Makes fireplace more efficient. Automatically turns off and on as needed.

CORNER MANTEL WITH Full HEARTH BASE (Not Shown)

GMC64FC Series - Oak Finished

GMC63UC Series - Unfinished

CS26CP Series - 2-Tone Finish (Black/

Lyptus)

GMC83FA Series - Oak Finished (Column

Style)

CMA208F Series - Oak Finished

For all models. Space saving mantel and hearth base corner design features clean, classic lines. Available in a stained oak, 2-tone finish or an unfinished hardwood, ready to stain or paint. Complete assembly instructions included. Three- sided perimeter trim kit included.

CABINET MANTEL and full hearth base (Not Shown)

GMC80FA Series - Oak Finished (Column

Style)

CMA204F Series - Oak Finished (Column

Style)

CMA205U Series - Unfinished (Column

Style)

CMA210W Series - White Lacquer Finished

CMA306F Series - Oak Finished

WS26CP Series - 2-Tone Finish (Black/

Lyptus)

WS26DLS Series - Lyptus Finished

GMC61UC Series - Unfinished

GMC60FC Series - Oak Finished

For all models. Mantel features clean, classic lines. Available in a stained oak, 2-tone finish or an unfinished hardwood, ready to stain or paint. Complete assembly instructions included. Three sided perimeter trim kit included.

40

www.desatech.com

113133-01C

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Thermostat Models Vdcftna and Vdcftpa Remote-Ready Models Shown with Optional Cabinet Mantel/Hearth Base AccessoryVdcfrpa and Vdcfrna Table of Contents Safety Information Safety Information Optional Remote Control Accessories Product FeaturesProduct Identification Local CodesAir for Combustion Ventilation Hood AssemblyTools Required Phillips screwdriver Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Fireplace Location Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installation Check GAS TypeInstallation Installation ItemsFireplace Clearances Fireplace pilot and burner must be at least 18 above floorBuilt-In Fireplace Installation If you have not installed hood, follow instruc- tions onOptional Mantel Installation Route flexible gas line through access hole in hearth baseCheck all gas connections for leaks. See Installing Optional Blower Accessory GA3450TARemoving Upper Louver Remove 4 screws from upper louver see . Save these screws Installing Blower AccessoryOpen lower louver door by swinging door down see Figure For Built-In Installation Extension CordConnecting to GAS Supply External Regulator With Vent Pointing DownInstallation Items Needed Connecting equipment shutoff valve to heater controlChecking GAS Connections Pressure Testing Fireplace Gas Connections Equipment Shutoff ValveInstalling Receiver Installing 9-Volt Battery in Hand-Held Remote Control UnitRemove battery cover on back of remote control unit Replace battery cover onto remote control unitOptional Wall Switch GWMS2 Remote-Ready Models Only Remove jumper wire from control valve see ,Installing LOG SET and Screen For Your Safety Read Before LightingOperating Fireplace Lighting InstructionsManual Lighting Procedure Operating FireplaceTo Turn OFF GAS To Appliance Thermostat Control OperationAUTO/OFF/ON Blower Switch Operating BlowerDepress control knob and light pilot with match Optional Hand-Held Remote OperationOn/Off Series Model HRC100 Thermostat Series Model HRC200Optional GWMS2 Wall Mounted Switch Safety FeaturesAuto Shutoff Feature Key Pad Lock FeatureCleaning Maintenance Inspecting BurnersPilot Flame Pattern Burner Flame PatternCleaning Maintenance Wiring DiagramLOG Set CabinetTroubleshooting Observed Problem Possible Cause RemedyTroubleshooting When heated, vapors from Mote-Ready Models Only Power is lowSlight smoke or odor during Initial operation Processes and log curingGas leak. See Warning Specifications VDCFTPA, VdcfrpaIllustrated Parts Breakdown Firebox Models VDCParts List Thermostat Models Illustrated Parts BreakdownVdcftpa and Vdcftna Parts List REMOTE-READY Models Vdcfrna and VdcfrpaKEY Equipment Shutoff Valve GA5010 AccessoriesTHERMOSTAT-CONTROLLED Blower KIT GA3450T Accessories WALL-MOUNT ON/OFF SwitchReceiver and HAND-HELD Thermostat Remote Control KIT HRC200 Receiver and HAND-HELD Remote Control KIT HRC100Replacement Parts Service HintsTechnical Service Parts Under Warranty113133-01C Keep this Warranty Warranty InformationLimited Warranty VENT-FREE Compact Classic Hearth
Top Page Image Contents