Desa VDCFTNA installation manual Gas leak. See Warning

Page 32

TROUBLESHOOTING

Continued

WARNING: If you smell gas

•Shut off gas supply.

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating fireplace where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM

POSSIBLE CAUSE

REMEDY

 

 

 

 

 

 

Fireplace produces unwanted

1. Fireplace burning vapors from

1.

Open window to ventilate

odors

 

paint, hair spray, glues, clean-

 

room. Stop using odor caus-

 

 

 

ers, chemicals, new carpet,

 

ing products while fireplace

 

 

 

etc. (See IMPORTANT state-

 

is running

 

 

2.

ment above)

2.

Refill supply tank (propane/LP

 

 

Low fuel supply (propane/LP

 

 

3.

only)

3.

only)

 

 

Gas leak. See Warning state-

Locate and correct all leaks

 

 

 

ment at top of page

 

(see Checking Gas Connec-

 

 

 

 

 

tions, page 17)

 

 

 

 

 

 

Fireplace shuts off in use (ODS

1. Not enough fresh air is

1.

Open window and/or door for

operates)

2.

available

2.

ventilation

 

 

Low line pressure

Contact local natural or pro-

 

 

3.

O D S / pi l o t i s pa rt i a l l y

3.

pane/LP gas company

 

 

Clean ODS/pilot (see Cleaning

 

 

 

clogged

 

and Maintenance, page 27)

 

 

 

 

 

Gas odor even when control

1. Gas leak. See Warning

1.

Locate and correct all leaks

 

knob is in OFF position

 

statement at top of page

 

(see Checking Gas Connec-

 

 

2.

Control valve defective

2.

tions, page 17)

 

 

Replace control valve

 

 

 

 

 

Gas odor during combustion

1. Foreign matter between con-

1.

Take apart gas tubing and

 

 

2.

trol valve and burner

2.

remove foreign matter

 

 

Gas leak. See Warning

Locate and correct all leaks

 

 

 

statement at top of page

 

(see Checking Gas Connec-

 

 

 

 

 

tions, page 17)

32

www.desatech.com

113133-01C

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Vdcfrpa and Vdcfrna Shown with Optional Cabinet Mantel/Hearth Base AccessoryThermostat Models Vdcftna and Vdcftpa Remote-Ready Models Table of Contents Safety Information Safety Information Optional Remote Control Accessories Product FeaturesProduct Identification Local CodesTools Required Phillips screwdriver Hood AssemblyAir for Combustion Ventilation Determining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Installation Check GAS TypeInstallation Installation ItemsFireplace Clearances Fireplace pilot and burner must be at least 18 above floorBuilt-In Fireplace Installation If you have not installed hood, follow instruc- tions onOptional Mantel Installation Route flexible gas line through access hole in hearth baseRemoving Upper Louver Installing Optional Blower Accessory GA3450TACheck all gas connections for leaks. See Open lower louver door by swinging door down see Figure Installing Blower AccessoryRemove 4 screws from upper louver see . Save these screws For Built-In Installation Extension CordConnecting to GAS Supply External Regulator With Vent Pointing DownChecking GAS Connections Connecting equipment shutoff valve to heater controlInstallation Items Needed Pressure Testing Fireplace Gas Connections Equipment Shutoff ValveInstalling Receiver Installing 9-Volt Battery in Hand-Held Remote Control UnitRemove battery cover on back of remote control unit Replace battery cover onto remote control unitOptional Wall Switch GWMS2 Remote-Ready Models Only Remove jumper wire from control valve see ,Installing LOG SET and Screen For Your Safety Read Before LightingOperating Fireplace Lighting InstructionsManual Lighting Procedure Operating FireplaceTo Turn OFF GAS To Appliance Thermostat Control OperationAUTO/OFF/ON Blower Switch Operating BlowerDepress control knob and light pilot with match Optional Hand-Held Remote OperationOn/Off Series Model HRC100 Thermostat Series Model HRC200Optional GWMS2 Wall Mounted Switch Safety FeaturesAuto Shutoff Feature Key Pad Lock FeatureCleaning Maintenance Inspecting BurnersPilot Flame Pattern Burner Flame PatternCleaning Maintenance Wiring DiagramLOG Set CabinetTroubleshooting Observed Problem Possible Cause RemedyTroubleshooting When heated, vapors from Mote-Ready Models Only Power is lowSlight smoke or odor during Initial operation Processes and log curingGas leak. See Warning Specifications VDCFTPA, VdcfrpaIllustrated Parts Breakdown Firebox Models VDCParts List Vdcftpa and Vdcftna Illustrated Parts BreakdownThermostat Models Parts List REMOTE-READY Models Vdcfrna and VdcfrpaKEY THERMOSTAT-CONTROLLED Blower KIT GA3450T AccessoriesEquipment Shutoff Valve GA5010 Accessories WALL-MOUNT ON/OFF SwitchReceiver and HAND-HELD Thermostat Remote Control KIT HRC200 Receiver and HAND-HELD Remote Control KIT HRC100Replacement Parts Service HintsTechnical Service Parts Under Warranty113133-01C Limited Warranty VENT-FREE Compact Classic Hearth Warranty InformationKeep this Warranty
Top Page Image Contents