Brinkmann 8300 owner manual Before Storing Your Grill, Trouble Shooting

Page 18

BEFORE STORING YOUR GRILL:

•Ensure that the cylinder valve is fully closed.

•Clean all surfaces.

•Lightly coat the burners with cooking oil to prevent excess rusting.

•If storing the grill indoors, disconnect the LP tank and leave the LP tank OUTDOORS.

•Place a protective cap cover on the LP tank and store the tank outdoors in a well ventilated area out of direct sunlight.

•Clean burner prior to use after storing, at the beginning of grilling season or after a period of one month not being used. Spiders and insects like to build nests in burner tubes (especially during colder months). These nests can cause fires in burner tubes or under grill.

•If storing the grill outdoors, cover the grill with a grill cover for protection from the weather.

TROUBLE SHOOTING

Problem:

• Burner will not light

•Fire at control knob

•Yellow Flames at burner

•Flame blows out on "LOW"

•Burner does not get hot enough

•Grill is Too Hot

Possible Causes:

1.Check LP cylinder fuel level.

2.Bad electrode spark.

Check to see if the grill will match light. Electrode or collector may need adjustment.

3.Burner may not be properly seated.

4.Burner may be obstructed.

5.The cylinder valve may be closed.

6.Regulator is not properly seated on cylinder valve.

1.Burner holes may be obstructed. See section on "Burner Assembly/Maintenance" under Proper Care and Maintenance.

2.Burner is improperly seated on control valve.

3.Gas connections may be loose.

Leak Check and tighten all connections.

1.Burner is obstructed. See section on

"Burner Assembly/Maintenance" under Proper Care and Maintenance.

1.Burner holes may be obstructed. See section on "Burner Assembly/Maintenance" under Proper Care and Maintenance.

2.Grill is not sufficiently preheated.

3.Burner is improperly seated on control valve.

1.Flow control device has been activated in regulator. See Regulator Resetting Procedure under Connecting LP Cylinder and Hose/Regulator to Grill.

1.Excess grease build-up causing grease fires.

2.Damaged or faulty regulator. Replace with factory authorized parts.

3.Cook on a lower temperature setting.

17

Image 18

Contents Avis À L’INSTALLATEUR Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorLeak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Side Burner Match Lighting the Side BurnerTurning OFF the Grill Preheating the Grill Operating the GrillBreaking in Your Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerCleanliness Grilling to Proper TemperatureHelpful Hints Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCECooking Grills Heat Distribution PlatesTransporting and Storage Trouble Shooting Before Storing Your GrillFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions Parts List1519 Step Snap wheel hubcaps onto the outside of wheels as illustrated Grill Body Assembly Step Attach hose heat shield using two #8 self-tapping screws Step Place the side burner grate onto the side burner table Step Portland 8300 Assembled Mises EN Garde Importantes Relatives À LA SécuritéTable DES Matières Mises EN Garde Générales Mises EN GardeRenseignements SUR L’INSTALLATION Bouteille DE GPL NON Fournie Avec CE GrilSpécifications DE LA Bouteille Tuyau ET Régulateur Installation DE LA Bouteille DE GPL SUR LE GrilRemplissage DE LA Bouteille DE GPL Procédure DE Réenclenchement DU RégulateurRaccordement DE L’ENSEMBLE Tuyau / Détendeur Épreuves D’ÉTANCHÉITÉ Quand Effectuer UNE Épreuve D’ÉTANCHÉITÉListe DE Contrôle Avant L’ALLUMAGE Consignes D’ALLUMAGE Allumage DES Brûleurs PrincipauxAllumage DES Brûleurs Principaux À L’AIDE D’UNE Allumette Allumage DU Brûleur Latéral Allumage DU Brûleur Latéral À L’AIDE D’UNE AllumetteFermeture DU Gril Préchauffage DU Gril Utilisation DU GrilMise EN Marche DE Votre Gril Contrôle DES EmbrasementsCuisson AU Tournebroche Brûleur LatéralPropreté Grillage À LA Bonne TempératureConseils Utiles Nettoyage ET Entretien Assemblage ET Entretien DES BrûleursPlaques DE Diffusion Thermique Assemblage DU Brûleur / Entretien SuiteGrilles DE Cuisson Transport ET EntreposageAvant Dentreposer Votre Gril DépannageQuestions Posées Fréquemment Questions Posées Fréquemment Instructions D’ASSEMBLAGE Liste DES PiècesPage Contenu DU SAC DE Pièces Étape Étape LAssemblage du Corps du Grill Étape Étape Avertissement Contenant à Graisse Plateau à Graisse Étape Portland 8300 Assemblé Warranty