BURNER ASSEMBLY/MAINTENANCE CONTINUED
5.Carefully lift each burner up and away from valve openings.
6.Use a narrow bottle brush or a stiff wire bent into a small hook to run through each burner tube and flame port several times.
Note: Wear eye protection when performing procedure 7
7.Use compressed air to blow into burner tube and out the flame ports. Check each port to make sure air comes out each hole.
8.Wire brush entire outer surface of burner to remove food residue and dirt.
9.Check burner for damage, if any large cracks or holes are found replace burner.
IMPORTANT: Burner opening must slide over valve nozzle.
10.Carefully align crossover channels between burners and orient burners CORRECTLY by aligning screw hole in burner to the left as shown.
11.Replace M5 screws to each burner and crossover channel.
M5 Screw
Crossover Channel
Valve Nozzle
Burner Opening
Note: Follow the "Gas Leak Testing" section of this manual. Relight burners to verify proper operation.
12. Replace heat distribution plates and cooking grills.
PROPER BURNER OPERATION
COOKING GRILLS
•Clean with mild soap detergent and water. A brass bristled brush or a nylon cleaning pad can be used to remove residue from the stainless steel surfaces. Do not use steel wire bristles to clean the cooking grills. Steel can cause the finish to chip or crack. DO NOT use a commercial oven cleaner.
HEAT DISTRIBUTION PLATES
•Periodically, it may be necessary to inspect and clean the heat distribution plate to prevent excess grease
Operate the grill on "HIGH" for 10 minutes to remove the excess grease.
19