Brinkmann Charcoal/Gas Grill owner manual Connecting Hose and Regulator to AN LP GAS Cylinder

Page 8

WARNING

Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

WARNING

The pressure regulator and hose assembly supplied with your gas grill must be used.

DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.

DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill. Replacement pressure regulator/hose assembly must be part No 155-3248-0, which can be obtained by contacting customer service at 800-527-0717.

DO NOT attempt to adjust or repair the regulator. The regulator is designed to operate at a maximum output pressure of 11 inches of water column (2.74 kPa).

During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.

Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your grill. Only the manufacturer's supplied replacement should be used.

WARNING

CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER

Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the valve knob clockwise to properly close the valve. Read and follow all instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and follow all warnings on the LP cylinder.

CONNECTING HOSE AND REGULATOR

1.Check that the cylinder valve is closed by turning the knob clockwise.

2.Check that the grill’s burner control knobs are in the "OFF" positions.

3.Remove the protective plastic cap from the cylinder valve.

4.Hold regulator and insert the nipple of connection device into the LP cylinder valve outlet. Ensure that the device is centered properly.

5.Turn the large coupling nut clockwise by hand and tighten to a full stop. Take care not to cross thread the coupling nut onto the cylinder valve. Do not over-tighten the knob onto the valve. Do not use tools to tighten connection.

Note: If you are unable to make the connection, repeat Steps 4 and 5.

6.Check that the hose does not contain kinks, does not contact sharp edges, and does not contact surfaces that may become hot during use.

7.Leak check all fittings before lighting your grill. See section on "Leak Testing" in this manual.

7

Image 8
Contents Professional Dual Zone Important Safety Table of Contents GAS Grill General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Installing the LP GAS Cylinder Onto the Grill Regulator Resetting ProcedureFilling the LP GAS Cylinder Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Operating the GrillBreaking in Your Grill Preheating the GrillCleanliness Grilling to Proper TemperatureTo Minimize FLARE-UPS Indirect CookingCharcoal Grill General Warnings Page Charcoal Operating Instructions Preheating Your GrillGRILLING/SEARING Flavoring WoodTo Increase Heat Adding CHARCOAL/WOOD During CookingAFTER-USE Safety Transporting and StorageBurner ASSEMBLY/MAINTENANCE Proper Care & MaintenanceCleaning and Maintenance Cooking Grills Heat Distribution PlatesTrouble Shooting Before Storing Your GrillFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions Parts ListPage Step Gas Manifold Bottom Door Pivots Top Door Door Grill Body NutAssembly Door Locking Plate AA/1.5V Alkaline Battery Igniter Cap Control Knobs Slide the drawer into the left side table Attach the divider using two M6 X 12mm bolts and two M6 nuts Brinkmann 3248 Assembled Importantes Advertencias DE Seguridad PeligroSección DE LA Parrilla DE GAS Sección DEL Carbón DE LeñaAdvertencias Generales Para LA Parrilla DE GAS Información DE Instalación Especificaciones DEL Cilindro Llenado DEL Cilindro DE GAS DE Propano Líquido Manguera Y ReguladorConexión DE LA Mangueray Regulador Verificación DE Ausencia DE Fugas Pruebas DE Detección DE FugasCuándo Realizar UNA Prueba DE Detección DE Fugas Lista DE Verificación Preliminar AL Encendido ¡PRECAUCIÓNInstrucciones DE Encendido Siga las instrucciones al pie de la letraApagado DE LA Parrilla Operación DE LA ParrillaPreparación DE LA Parrilla Para Usarla POR Primera VEZ Precalentamiento DE LA ParrillaPara Reducir AL Mínimo LAS Llamaradas Cocción IndirectaLimpieza Cocinar a LA Parrilla a LA Temperatura ApropiadaAdvertencia Advertencia Instrucciones DE Operación DE LA Parrilla DE Carbón DE Leña Cómo Precalentar SU ParrillaCómo Asar Y Chamuscar Leña QUE Imparte SaborCómo Incrementar LA Temperatura Cómo Añadir Carbón O Leña Durante EL CocimientoCómo Añadir Carbón O Leña Durante EL Cocimiento Continuada Transporte Y AlmacenamientoCómo Ensamblar Y Darle Mantenimiento a LOS Quemadores Debido Cuidado Y MantenimientoLimpieza Y Mantenimiento Parrillas Para Cocinar Placas DE Distribución TérmicaResolución DE Problemas Antes DE Almacenar SU ParrillaPreguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Piezas LA Tarjeta DE Piezas ContieneInstrucciones DE Ensamblado Lista de PiezasPage Paso Advertencia Pivotes de La Puerta Inferior Ensamblado del Cuerpo de la Parrilla Pila alcalina AA de Tapa del Ecendedor Perillas de Control Deslice el cajón para meterlo a la mesa lateral izquierda Una el divisor con dos pernos M6 X 12mm y dos tuercas M6 Brinkmann 3248 Armada Warranty