Brinkmann Charcoal/Gas Grill owner manual Filling the LP GAS Cylinder, Hose and Regulator

Page 7

WARNING

FILLING THE LP GAS CYLINDER:

•Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder.

•New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank.

•DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can create a dangerous condition. Over-filled tanks can build-up pressure and cause the relief valve to expel propane gas vapors. The vapor is combustible and if it comes in contact with a spark source or flame an explosion causing severe burns, bodily harm, or death could occur.

•Always use a protective cylinder cap when grill is not connected to cylinder.

•If you exchange a cylinder with a qualified exchange program, be sure the cylinder has a Type 1 valve and an over-filling prevention device (OPD).

INSTALLING THE LP GAS CYLINDER ONTO THE GRILL:

1.Check that the cylinder valve is closed by turning the knob clockwise.

2.Place the cylinder into the tank holder in the bottom of cabinet.

3.Orient the cylinder such that the valve opening faces the right side table and so that the hose is not kinked or damaged.

4.Make sure tank sits securely in tank holder.

5.Attach or detach regulator to the LP gas cylinder only when cylinder is at rest in tank holder.

HOSE AND REGULATOR:

Your grill is equipped with a Type 1 connection device with the following features:

1.The system will not allow gas flow from the cylinder until a positive connection to the valve has been made.

Note: The cylinder valve must be turned off before any connection is made or removed.

2.A thermal device that will shut off the gas flow if the device is subject to temperatures above 240°F to 300°F (115°C to 150°C). If this should happen, remove the entire regulator assembly and dispose of properly. A replacement regulator assembly can be purchased by contacting customer service at 800-527-0717. The cause of the excessive heat should be determined and corrected before using your grill again.

3.A regulator flow limiting device, when activated, restricts the flow of gas to 10 cubic feet per hour. If the flow limiting device is activated, perform Regulator Resetting Procedure.

Tank Holder

Tank Holder

REGULATOR RESETTING PROCEDURE

1.Turn burner control knobs to "OFF”, turn off the cylinder valve and disconnect regulator from LP gas tank. Wait approximately two minutes.

2.Reattach regulator and slowly turn cylinder valve back on. The flow limiting device will now be reset.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Professional Dual Zone Important Safety Table of Contents GAS Grill General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Hose and Regulator Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Filling the LP GAS CylinderConnecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderWhen to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Preheating the Grill Turning OFF the GrillOperating the Grill Breaking in Your GrillIndirect Cooking CleanlinessGrilling to Proper Temperature To Minimize FLARE-UPSCharcoal Grill General Warnings Page Preheating Your Grill Charcoal Operating InstructionsAdding CHARCOAL/WOOD During Cooking GRILLING/SEARINGFlavoring Wood To Increase HeatTransporting and Storage AFTER-USE SafetyCleaning and Maintenance Proper Care & MaintenanceBurner ASSEMBLY/MAINTENANCE Heat Distribution Plates Cooking GrillsBefore Storing Your Grill Trouble ShootingFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Parts List Assembly InstructionsPage Step Gas Manifold Bottom Door Pivots Top Door Door Grill Body NutAssembly Door Locking Plate AA/1.5V Alkaline Battery Igniter Cap Control Knobs Slide the drawer into the left side table Attach the divider using two M6 X 12mm bolts and two M6 nuts Brinkmann 3248 Assembled Peligro Importantes Advertencias DE SeguridadSección DEL Carbón DE Leña Sección DE LA Parrilla DE GASAdvertencias Generales Para LA Parrilla DE GAS Información DE Instalación Especificaciones DEL Cilindro Manguera Y Regulador Llenado DEL Cilindro DE GAS DE Propano LíquidoConexión DE LA Mangueray Regulador Cuándo Realizar UNA Prueba DE Detección DE Fugas Pruebas DE Detección DE FugasVerificación DE Ausencia DE Fugas ¡PRECAUCIÓN Lista DE Verificación Preliminar AL EncendidoSiga las instrucciones al pie de la letra Instrucciones DE EncendidoPrecalentamiento DE LA Parrilla Apagado DE LA ParrillaOperación DE LA Parrilla Preparación DE LA Parrilla Para Usarla POR Primera VEZCocinar a LA Parrilla a LA Temperatura Apropiada Para Reducir AL Mínimo LAS LlamaradasCocción Indirecta LimpiezaAdvertencia Advertencia Cómo Precalentar SU Parrilla Instrucciones DE Operación DE LA Parrilla DE Carbón DE LeñaCómo Añadir Carbón O Leña Durante EL Cocimiento Cómo Asar Y ChamuscarLeña QUE Imparte Sabor Cómo Incrementar LA TemperaturaTransporte Y Almacenamiento Cómo Añadir Carbón O Leña Durante EL Cocimiento ContinuadaLimpieza Y Mantenimiento Debido Cuidado Y MantenimientoCómo Ensamblar Y Darle Mantenimiento a LOS Quemadores Placas DE Distribución Térmica Parrillas Para CocinarAntes DE Almacenar SU Parrilla Resolución DE ProblemasPreguntas Frecuentes Preguntas Frecuentes LA Tarjeta DE Piezas Contiene Contenido DE LA Bolsa DE PiezasLista de Piezas Instrucciones DE EnsambladoPage Paso Advertencia Pivotes de La Puerta Inferior Ensamblado del Cuerpo de la Parrilla Pila alcalina AA de Tapa del Ecendedor Perillas de Control Deslice el cajón para meterlo a la mesa lateral izquierda Una el divisor con dos pernos M6 X 12mm y dos tuercas M6 Brinkmann 3248 Armada Warranty
Top Page Image Contents