Avaya AP41 Dynamic RF Management ARM Aware Scanning, Security Policies and Quality of Service QoS

Page 14

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

Dynamic RF Management - ARM Aware Scanning

If Adaptive Radio Resource Management (ARM) Aware Scanning (RF scanning) is included in your firmware release, it can be enabled through the command line interface as follows:

configure terminal ap location x.y.z phy-type g

arm scanning enable

arm assignment single-band arm voip-aware-scan enable write mem

This feature was enabled during VIEW Certification testing in a screen room (strong signals in a clean environment). A real-world test with interfering RF signals was not simulated.

Security Policies and Quality of Service (QoS)

Once the basic infrastructure is configured, it is necessary to configure the security policies to ensure that the data network and the voice network are secured and access to these networks is limited as required.

The steps are as follows:

1.Setup aliases for the AVPP.

2.Set policies for the wireless IP telephone User to the required voice server, DHCP and TFTP servers. Add other ACLs as required to permit other traffic from the wireless IP telephones.

3.Assign policies to the role.

Page 14

Image 14

Contents Certified Product Summary Service InformationConfiguration Guide View CertifiedNetwork Topology Interface settingDefault route Deployment DescriptionCommand, comment, and screen text key Connecting to the Mobility ControllerConnecting the APs Known LimitationsVia the Web interface Ssh admin@switch IP addressVia the CLI Initial Setup Welcome to Aruba Wireless Networks ArubaProvisioning APs Connecting APsAssigning an IP to the Mobility Controller Web-based configuration Ssid ConfigurationCLI command configuration Configure terminal ap location x.y.zPreamble settings Access Point ConfigurationRadio setting 802.11b or 802.11g Enter the PSK AES Key/PassphraseChannel and Tx power Recommended AP configuration settingsEssid Commands Ap location x.y.zFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Security Policies and Quality of Service QoS Dynamic RF Management ARM Aware ScanningCreate policies for the wireless IP telephone user Create an alias for the AvppAssign policies to the role Subnet Roaming AuthenticationQuality of Service QoS User-role phones session-acl phoneaclCLI commands to set up subnet roaming Commands for the master switch the ArubaFrom the Aruba Commands to verify setup for sub-net routingCommands for the local switch the Aruba Show stm connectivity Checking the ConfigurationShow ap config location x.y.z Show station-table