Avaya AP60, AP65 CLI commands to set up subnet roaming, Commands for the master switch the Aruba

Page 18

Aruba Mobility Controller

Configuration Guide

 

VIEW Certified

Ensure that both switches have IP connectivity. A simple ping from each of the switches to the other switch can be used to verify connectivity. In a master local setup all AP, authentication, and firewall configurations will be made on the master and pushed down to the local switch.

In the configuration tested, all APs with location code 1.1.0 were configured to boot off of the master switch and all APs with location code 1.2.0 were configured to boot off of the local switch.

To use the Web interface to configure the switches for subnet roaming, do the following:

1.From the master switch navigate to the Configuration > WLAN > Advanced tab.

2.Add a new location 1.1.0 and click the Apply button.

3.In the next page click General and set the LMSIP to the switch IP address of the master.

4.Apply the configurations.

5.Configure location 1.2.0 in a similar manner and set the LMSIP address to the switch IP address of the local switch.

6.Create a default route for multicast traffic re-direction on the switch that acts as the Mobility Home Agent for the Voice group (this was done on the master switch in the test example).

CLI commands to set up subnet roaming

Commands for the master switch (the Aruba 800):

Configure terminal

ip default-gateway <ip_addr of router>

ap location 1.1.0 (AP connected to the Aruba 800) lms-ip <ip_addr of 800 switch>

ap location 1.2.0 (AP connected to the Aruba 6000) lms-ip <ip_addr of 6000 switch>

ip route 224.0.0.0 255.0.0.0 <ip_addr of NetLink Gateway> exit

write mem

Page 18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Certified Product Summary Service InformationConfiguration Guide View CertifiedNetwork Topology Interface settingDefault route Deployment DescriptionCommand, comment, and screen text key Connecting to the Mobility ControllerConnecting the APs Known LimitationsSsh admin@switch IP address Via the CLIVia the Web interface Initial Setup Welcome to Aruba Wireless Networks ArubaConnecting APs Assigning an IP to the Mobility ControllerProvisioning APs Web-based configuration Ssid ConfigurationCLI command configuration Configure terminal ap location x.y.zPreamble settings Access Point ConfigurationRadio setting 802.11b or 802.11g Enter the PSK AES Key/PassphraseChannel and Tx power Recommended AP configuration settingsEssid Commands Ap location x.y.zFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Security Policies and Quality of Service QoS Dynamic RF Management ARM Aware ScanningCreate policies for the wireless IP telephone user Create an alias for the AvppAssign policies to the role Subnet Roaming AuthenticationQuality of Service QoS User-role phones session-acl phoneaclCLI commands to set up subnet roaming Commands for the master switch the ArubaCommands to verify setup for sub-net routing Commands for the local switch the ArubaFrom the Aruba Show stm connectivity Checking the ConfigurationShow ap config location x.y.z Show station-table
Top Page Image Contents