Avaya AP70, AP60, AP65, A2400, A200, A800, AP41, AP61, A6000 manual Assign policies to the role

Page 16

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

Assign policies to the role

Create a role, for example phones, and assign the policies to this role. This is the role that will be assigned to the handsets when they are authenticated successfully.

The Security Policies and QoS can also be configured through the command line interface (CLI). The CLI commands corresponding to this section are as follows:

configure terminal netdestination tftp-server host 10.168.0.20

netdestination avpp host 10.168.0.11 host 10.168.0.12

netdestination dhcp-server host 10.168.0.21

ip access-list session phone_acl user user any deny

user alias avpp svc-avpp permit queue high alias avpp user svc-avpp permit queue high user alias tftp-server svc-tftp permit user alias dhcp-server svc-dhcp permit user host 224.0.1.116 any permit

Page 16

Image 16

Contents Service Information Configuration GuideCertified Product Summary View CertifiedInterface setting Default routeNetwork Topology Deployment DescriptionConnecting to the Mobility Controller Connecting the APsCommand, comment, and screen text key Known LimitationsVia the CLI Ssh admin@switch IP addressVia the Web interface Initial Setup Welcome to Aruba Wireless Networks ArubaAssigning an IP to the Mobility Controller Connecting APsProvisioning APs Ssid Configuration CLI command configurationWeb-based configuration Configure terminal ap location x.y.zAccess Point Configuration Radio setting 802.11b or 802.11gPreamble settings Enter the PSK AES Key/PassphraseChannel and Tx power Recommended AP configuration settingsEssid Commands Ap location x.y.zFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Security Policies and Quality of Service QoS Dynamic RF Management ARM Aware ScanningCreate policies for the wireless IP telephone user Create an alias for the AvppAssign policies to the role Authentication Quality of Service QoSSubnet Roaming User-role phones session-acl phoneaclCLI commands to set up subnet roaming Commands for the master switch the ArubaCommands for the local switch the Aruba Commands to verify setup for sub-net routingFrom the Aruba Checking the Configuration Show ap config location x.y.zShow stm connectivity Show station-table