Avaya A2400, AP60, AP65, A200, A800, AP41, AP61, AP70, A6000 manual Ap location x.y.z, Commands

Page 11

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

All of the commands listed in the CLI Commands column above must be entered under the ap

location command.

The format is:

ap location x.y.z

phy-type g (To make the changes for the “g” radio.) commands

phy-type a (To make the changes for the “a” radio.)

Page 11

Image 11

Contents View Certified Service InformationConfiguration Guide Certified Product SummaryDeployment Description Interface settingDefault route Network TopologyKnown Limitations Connecting to the Mobility ControllerConnecting the APs Command, comment, and screen text keyVia the Web interface Ssh admin@switch IP addressVia the CLI Welcome to Aruba Wireless Networks Aruba Initial SetupProvisioning APs Connecting APsAssigning an IP to the Mobility Controller Configure terminal ap location x.y.z Ssid ConfigurationCLI command configuration Web-based configurationEnter the PSK AES Key/Passphrase Access Point ConfigurationRadio setting 802.11b or 802.11g Preamble settingsRecommended AP configuration settings Channel and Tx powerEssid Ap location x.y.z CommandsFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Dynamic RF Management ARM Aware Scanning Security Policies and Quality of Service QoSCreate an alias for the Avpp Create policies for the wireless IP telephone userAssign policies to the role User-role phones session-acl phoneacl AuthenticationQuality of Service QoS Subnet RoamingCommands for the master switch the Aruba CLI commands to set up subnet roamingFrom the Aruba Commands to verify setup for sub-net routingCommands for the local switch the Aruba Show station-table Checking the ConfigurationShow ap config location x.y.z Show stm connectivity