Avaya AP61, AP60 Create an alias for the Avpp, Create policies for the wireless IP telephone user

Page 15

Aruba Mobility Controller

Configuration Guide

 

VIEW Certified

Create an alias for the AVPP

1.Click the Configuration tab.

2.In the navigation pane, select Advanced from the Security sub-menu.

3.Click the Destinations tab.

4.To add a new destination, click the Add button.

5.Create a new net-destination at Destination Name (e.g. avpp), and add the AVPPs as hosts. For more details on configuring the net-destinations refer to the Aruba User Guide.

Create policies for the wireless IP telephone user

The policies shown in the above example can be configured using the Web interface as follows:

Page 15

Image 15
Contents View Certified Service InformationConfiguration Guide Certified Product SummaryDeployment Description Interface settingDefault route Network TopologyKnown Limitations Connecting to the Mobility ControllerConnecting the APs Command, comment, and screen text keySsh admin@switch IP address Via the CLIVia the Web interface Welcome to Aruba Wireless Networks Aruba Initial SetupConnecting APs Assigning an IP to the Mobility ControllerProvisioning APs Configure terminal ap location x.y.z Ssid ConfigurationCLI command configuration Web-based configurationEnter the PSK AES Key/Passphrase Access Point ConfigurationRadio setting 802.11b or 802.11g Preamble settingsRecommended AP configuration settings Channel and Tx powerEssid Ap location x.y.z CommandsFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Dynamic RF Management ARM Aware Scanning Security Policies and Quality of Service QoSCreate an alias for the Avpp Create policies for the wireless IP telephone userAssign policies to the role User-role phones session-acl phoneacl AuthenticationQuality of Service QoS Subnet RoamingCommands for the master switch the Aruba CLI commands to set up subnet roamingCommands to verify setup for sub-net routing Commands for the local switch the ArubaFrom the Aruba Show station-table Checking the ConfigurationShow ap config location x.y.z Show stm connectivity