Avaya AP65 Commands to verify setup for sub-net routing, Commands for the local switch the Aruba

Page 19

Aruba Mobility Controller

Configuration Guide

 

VIEW Certified

Commands for the local switch (the Aruba 6000):

The AP's IP address must be on same sub-net as the switch.

Configure terminal

masterip <ip address of the master> interface loopback

ip address <ip_addr of the 6000> vlan 1

interface vlan 1

ip address <ip_addr of the 6000> <netmask> interface fastethernet <port>

switchport access vlan 1 (only if the port is an access port) trusted

no shut

!

ip default-gateway <ip_addr of router>

!

exit write mem

After the master IP and the switch IP address are configured on the local switch, the switch needs to be rebooted prior to use.

It is also necessary to set the default gateway of the Avaya Voice Priority Processor and NetLink Telephony Gateway to the IP address of the router connected to the master switch.

Commands to verify setup for sub-net routing

From the Aruba 800:

show

master ip

(should be 800’s ip)

show

stm connectivity

(shows the APs connected to the Aruba

 

 

800 switch)

Ping the local switch.

Pings should be successful.

From the Aruba 6000:

show master ip

(should be 800’s ip)

show

stm connectivity

(shows the APs connected to the Aruba

 

 

6000 switch)

show

running configuration (shows ap & aaa rules are carried from

 

 

the master to the slave)

Page 19

Image 19
Contents View Certified Service InformationConfiguration Guide Certified Product SummaryDeployment Description Interface settingDefault route Network TopologyKnown Limitations Connecting to the Mobility ControllerConnecting the APs Command, comment, and screen text keyVia the CLI Ssh admin@switch IP addressVia the Web interface Welcome to Aruba Wireless Networks Aruba Initial SetupAssigning an IP to the Mobility Controller Connecting APsProvisioning APs Configure terminal ap location x.y.z Ssid ConfigurationCLI command configuration Web-based configurationEnter the PSK AES Key/Passphrase Access Point ConfigurationRadio setting 802.11b or 802.11g Preamble settingsRecommended AP configuration settings Channel and Tx powerEssid Ap location x.y.z CommandsFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Dynamic RF Management ARM Aware Scanning Security Policies and Quality of Service QoSCreate an alias for the Avpp Create policies for the wireless IP telephone userAssign policies to the role User-role phones session-acl phoneacl AuthenticationQuality of Service QoS Subnet RoamingCommands for the master switch the Aruba CLI commands to set up subnet roamingCommands for the local switch the Aruba Commands to verify setup for sub-net routingFrom the Aruba Show station-table Checking the ConfigurationShow ap config location x.y.z Show stm connectivity