Avaya A200, AP60, AP65, A2400, A800 Web-based configuration, For ARM Assignment, select Disabled

Page 12

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

Web-based configuration

1.Click the Configuration button.

2.In the navigation pane, select Radio from the WLAN sub-menu.

3.Click the 802.11b/g tab.

4.For Max Retries, enter 2 for voice.

5.Select the Short Preamble check box.

6.For the DTIM period, enter 3.

7.For Basic Rates and Supported Rates, consult the facility’s RF site survey to determine if coverage is sufficient to support all data rates.

8.To assign the power and channel setting manually:

b.Clear the ARM Scanning check box.

c.Set the Default Channel and Initial Transmit Power from their drop-down lists.

9.For Mode, click the Access-pointoption.

10.Click the Apply button.

Page 12

Image 12

Contents Service Information Configuration GuideCertified Product Summary View CertifiedInterface setting Default routeNetwork Topology Deployment DescriptionConnecting to the Mobility Controller Connecting the APsCommand, comment, and screen text key Known LimitationsSsh admin@switch IP address Via the CLIVia the Web interface Initial Setup Welcome to Aruba Wireless Networks ArubaConnecting APs Assigning an IP to the Mobility ControllerProvisioning APs Ssid Configuration CLI command configurationWeb-based configuration Configure terminal ap location x.y.zAccess Point Configuration Radio setting 802.11b or 802.11gPreamble settings Enter the PSK AES Key/PassphraseChannel and Tx power Recommended AP configuration settingsEssid Commands Ap location x.y.zFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Security Policies and Quality of Service QoS Dynamic RF Management ARM Aware ScanningCreate policies for the wireless IP telephone user Create an alias for the AvppAssign policies to the role Authentication Quality of Service QoSSubnet Roaming User-role phones session-acl phoneaclCLI commands to set up subnet roaming Commands for the master switch the ArubaCommands to verify setup for sub-net routing Commands for the local switch the ArubaFrom the Aruba Checking the Configuration Show ap config location x.y.zShow stm connectivity Show station-table