Avaya A800, AP60, AP65, A2400, A200, AP41, AP61, AP70, A6000 manual For ARM Assignment, select Disabled

Page 13

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

11.Click the 802.11 a tab.

12.For Max Retries, enter 2 for voice.

13.For the DTIM period, enter 3.

14.For Basic Rates and Supported Rates, consult the facilities RF site survey to determine if coverage is sufficient to support all data rates.

15.To assign the power and channel setting manually:

a.For ARM Assignment, select Disabled.

b.Clear the ARM Scanning check box.

c.Set the Default Channel and Initial Transmit Power from their drop-down lists.

16.For Mode, click the Access-pointoption.

17.Click the Apply button.

Page 13

Image 13

Contents Configuration Guide Service InformationCertified Product Summary View CertifiedDefault route Interface settingNetwork Topology Deployment DescriptionConnecting the APs Connecting to the Mobility ControllerCommand, comment, and screen text key Known LimitationsVia the CLI Ssh admin@switch IP addressVia the Web interface Welcome to Aruba Wireless Networks Aruba Initial SetupAssigning an IP to the Mobility Controller Connecting APsProvisioning APs CLI command configuration Ssid ConfigurationWeb-based configuration Configure terminal ap location x.y.zRadio setting 802.11b or 802.11g Access Point ConfigurationPreamble settings Enter the PSK AES Key/PassphraseRecommended AP configuration settings Channel and Tx powerEssid Ap location x.y.z CommandsFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Dynamic RF Management ARM Aware Scanning Security Policies and Quality of Service QoSCreate an alias for the Avpp Create policies for the wireless IP telephone userAssign policies to the role Quality of Service QoS AuthenticationSubnet Roaming User-role phones session-acl phoneaclCommands for the master switch the Aruba CLI commands to set up subnet roamingCommands for the local switch the Aruba Commands to verify setup for sub-net routingFrom the Aruba Show ap config location x.y.z Checking the ConfigurationShow stm connectivity Show station-table