Avaya A800, AP60, AP65, A2400, A200 Via the CLI, Via the Web interface, Ssh admin@switch IP address

Page 4

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

Via the CLI

By default, only SSH (Secure SHell) access to the switch (mobility controller) is permitted.

1.From a management system that has network connectivity to the switch, connect to the switch using SSH:

ssh admin@<switch IP address>

2.Enter the admin password at the password prompt.

3.Type enable at the > prompt to enter the enable mode.

4.Type the enable password when prompted for a password.

Via the Web interface

Once the connectivity to the switch is verified, open a Web browser and enter the switch’s IP address in the navigator bar.

The switch can be accessed using http, http://<switch IP Address> or https, https://<switch IP Address>:4343.

The user is prompted with the username and password configured (in the example above, the username/password configured is admin/admin). On successful login the following

Network Summary screen is displayed:

Page 4

Image 4

Contents Service Information Configuration GuideCertified Product Summary View CertifiedInterface setting Default routeNetwork Topology Deployment DescriptionConnecting to the Mobility Controller Connecting the APsCommand, comment, and screen text key Known LimitationsVia the CLI Ssh admin@switch IP addressVia the Web interface Initial Setup Welcome to Aruba Wireless Networks ArubaAssigning an IP to the Mobility Controller Connecting APsProvisioning APs Ssid Configuration CLI command configurationWeb-based configuration Configure terminal ap location x.y.zAccess Point Configuration Radio setting 802.11b or 802.11gPreamble settings Enter the PSK AES Key/PassphraseChannel and Tx power Recommended AP configuration settingsEssid Commands Ap location x.y.zFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Security Policies and Quality of Service QoS Dynamic RF Management ARM Aware ScanningCreate policies for the wireless IP telephone user Create an alias for the AvppAssign policies to the role Authentication Quality of Service QoSSubnet Roaming User-role phones session-acl phoneaclCLI commands to set up subnet roaming Commands for the master switch the ArubaCommands for the local switch the Aruba Commands to verify setup for sub-net routingFrom the Aruba Checking the Configuration Show ap config location x.y.zShow stm connectivity Show station-table