Avaya AP70 Ssid Configuration, CLI command configuration, Web-based configuration, Write mem

Page 7

Aruba Mobility Controller

Configuration Guide

 

VIEW Certified

SSID Configuration

CLI command configuration

APs can be configured using the CLI or the Web interface. Each AP is identified by a unique location code. The APs can either be configured per location with unique settings using the AP’s unique location code or globally using the wildcard location. “0” is used as the wildcard.

Example: ap location 0.0.0 will configure all Aruba APs on the WLAN system. Both the Aruba APs and the Spectralink handsets support the 802.11a and the 802.11b/g radios. To apply the SSID to both bands configure the SSID as follows:

configure terminal ap location x.y.z

virtual-ap aruba vlan-id 26 opmode wpa2-aes-pskwpa-passphrase thisisthekey dtim-period 3

If the voice network needs to exist only in the 802.11a band, configure the virtual AP under the 802.11a settings on the controller.

configure terminal ap location x.y.z

phy-type a virtual-ap aruba vlan-id 26 opmode wpa2-aes-pskwpa-passphrase thisisthekey dtim-period 3

If the voice network needs to exist only in the 802.11g band , configure the virtual AP under the 802.11a settings on the controller.

configure terminal ap location x.y.z

phy-type g virtual-ap aruba vlan-id 26 opmode wpa2-aes-pskwpa-passphrase thisisthekey dtim-period 3

To save changes, enter:

write mem

Web-based configuration

1.Click the Configuration button.

2.In the navigation pane, select Network from the WLAN sub-menu.

a.To edit an existing AP profile, click the Edit button corresponding to the SSID.

b.To add a new profile, click the Add button.

3.Under Add SSID, enter aruba in the SSID field.

4.Select 802.11a/b/g from the Radio Type drop-down list.

5.For the SSID Default VLAN, enter the voice VLAN number.

6.For the DTIM Period, enter 3.

Page 7

Image 7
Contents View Certified Service InformationConfiguration Guide Certified Product SummaryDeployment Description Interface settingDefault route Network TopologyKnown Limitations Connecting to the Mobility ControllerConnecting the APs Command, comment, and screen text keyVia the CLI Ssh admin@switch IP addressVia the Web interface Welcome to Aruba Wireless Networks Aruba Initial SetupAssigning an IP to the Mobility Controller Connecting APsProvisioning APs Configure terminal ap location x.y.z Ssid ConfigurationCLI command configuration Web-based configurationEnter the PSK AES Key/Passphrase Access Point ConfigurationRadio setting 802.11b or 802.11g Preamble settingsRecommended AP configuration settings Channel and Tx powerEssid Ap location x.y.z CommandsFor ARM Assignment, select Disabled For ARM Assignment, select Disabled Dynamic RF Management ARM Aware Scanning Security Policies and Quality of Service QoSCreate an alias for the Avpp Create policies for the wireless IP telephone userAssign policies to the role User-role phones session-acl phoneacl AuthenticationQuality of Service QoS Subnet RoamingCommands for the master switch the Aruba CLI commands to set up subnet roamingCommands for the local switch the Aruba Commands to verify setup for sub-net routingFrom the Aruba Show station-table Checking the ConfigurationShow ap config location x.y.z Show stm connectivity