Maxon Telecom WL7-VERS. C-1K installation instructions Preparing and Positioning the Lift

PREPARING AND POSITIONING THE LIFT - Continued

11921 Slauson Ave.

	NOTE: You may use a template instead of the
	Lift for positioning the Lift on vehicle. To
	use a template, refer to USING TEM
	PLATE TO POSITION LIFT section in
	this Installation Manual.		WHEELCHAIR
5. Using an appropriate lifting device that
			LIFT	DOOR
	can safely lift 500 pounds, raise Lift to the
	wheelchair doorway. Place the Lift inside
	doorway (FIG. 24-1). Align outboard
	edge of Lift threshold plate parallel with
	outboard edge of doorway. The decal on	DECAL (FACES
	the underside of the Lift platform must	OUTBOARD)

face outboard (FIG. 24-1).

Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

6.Position the Lift according to the clearance di- mensions given in VEHICLE REQUIREMENTS section in this Installation Manual.

7.Remove lifting device and close wheelchair door. Enter the vehicle. Verify the wheelchair door closes correctly and the minimum clearance is 3/4”. If door will not close correctly, reposition the Lift.

8.Secure vehicle door wide open (FIG. 24-1).

9.Check under the vehicle floor for possible in- terference between the Lift base plate mount- ing bolts and the vehicle underbody. For example, check subframe members, wiring harnesses, cables, and fluid lines.

VEHICLE RH SIDE VIEW

FIG. 24-1

PATENTS PENDING 24