Maxon Telecom WL7-VERS. C-1K installation instructions ROUTE/CONNECT Cables & Hand Pendant

ROUTE/CONNECT CABLES & HAND PENDANT

! CAUTION

Never route an energized wire. Make sure the battery is disconnected. Always route electrical wire clear of any moving parts, brake lines, sharp edges, and ex- haust systems. Never route power cable next to a wiring harness on the vehicle. Do not loop excess cable. Cut the cable to fit and leave slack. Attach securely. If drilling is necessary, be sure to check underside of vehicle before drilling so you do not damage any fuel lines, vent lines, brake lines or wires. When routing electrical wire through a hole in vehicle floor, use supplied grommet to protect wires from chafing.

-4116 FAX (888) 771-7713

1.Locate and drill a 1-5/16” hole through the vehicle floor (FIG. 31-1). Drill the hole in a location that will be hidden by the pump cover and that will allow power cable to be routed to power input bracket (FIG. 31-1). Since the inter- lock system wiring from the Lift also branches out in that area, locate the hole so the 3-conductor Interlock system cable can be routed from the Lift through the vehicle floor to the vehicle safety in- terlock. Install the plastic grommet (FIG. 31-1)on the vehicle floor with 2 of the #12 self-drilling screws.

SELF-TAPPING

SCREWS

POWER

INPUT

BRACKET

LONG

POWER CABLE

Ave. Santa Fe Springs, CA. 90670 (800) 227

2.Route the long power cable (Kit item) from main circuit breaker (FIG. 31-2), underneath vehicle floor to power input bracket (FIG. 31-1).

3.Secure power cable every 8”-10”.

FIG. 31-1

LONG POWER

CABLE

GROMMET

11921 Slauson

90 AMP MAIN

CIRCUIT BREAKER

FIG. 31-2

31 PATENTS PENDING