Maxon Telecom WL7-VERS. C-1K Platform Tilt Adjustment Mandatory, Platform Lowered to Ground Level

PLATFORM TILT ADJUSTMENT (MANDATORY)

NOTE: The platform tilt adjustment is important for operation of the outboard roll- stop and for keeping platform level when it reaches the ground. Vehicle floor height, Lift and stiffness of the vehicle suspension may change the angle of platform on the ground.

11921 Slauson Ave. Santa

1.Make sure power switch (FIG. 44-1)is turned on. Lower the platform and stop approximately 4” above ground.

GROUND

LEVEL

PLATFORM

POWER

SWITCH

4”

Fe Springs,

PLATFORM LOWERED TO GROUND LEVEL

FIG. 44-1

CA. 90670 (800) 227-4116 FAX

2.Measure distance from front of the platform (1) to the ground (FIG. 44-2). Next, measure the distance from the bottom of the vertical arm (2) to the ground

(FIG. 44-2).

POWER

SWITCH

	VERTICAL
		ARM
GROUND
LEVEL
(1)	PLATFORM
			(2)

(888) 771-7713

3. The measurement at the vertical PLATFORM LOWERED TO GROUND LEVEL

arm (2) must be 1/2” -1” more thanFIG. 44-2the measurement at the front of

platform (1). For example: If you measure 4” at the front (1), then you should measure from 4-1/2” to 5” at the vertical arm (2). If there is not a 1/2” - 1” difference, go to step 4 to obtain the correct measurement.

PATENTS PENDING 44