Invacare P9000 service manual REMOVING/INSTALLING Shrouds

FWD WHEELCHAIRS PROCEDURE 8

Upper Limit

Switch

Bracket

Phillips

Screws,

Washers

and Lock-

nuts

Actuator

24o Back

Recline Angle

5-3/4 inches

61o

Magnetic Protractor - (Will read 61o when back

recline angle is at 114o

relative to the seat

frame)

FIGURE 13 - ADJUSTING LIMIT SWITCH

114o

5o Seat Angle

F

W

D

W

H

E

E

L

C H A I R S

REMOVING/INSTALLING SHROUDS	Removing Side Shrouds and Fillers
(FIGURE 14)	1. Remove the front shroud from the wheelchair. Refer
Removing Front Shroud	to REMOVING/INSTALLING FRONT SHROUD in
	this procedure of the manual.

1.Unclip the retaining strap securing the front shroud and battery box to the wheelchair.

2.Feed the retaining strap through the front shroud.

3.Remove the front shroud from the wheelchair.

Installing Front Shroud

1.Feed the retaining strap through the front shroud as shown in FIGURE 14.

2.Position the bottom of the front shroud between the battery box and the battery tray.

3.Clip the retaining strap together.

Removing Rear Shroud

1.Unclip the retaining strap securing the rear shroud and battery box to the wheelchair.

2.Feed the retaining strap through the rear shroud.

3.Remove the rear shroud from the wheelchair.

Installing Rear Shroud

1.Feed the retaining strap through the front shroud as shown in FIGURE 14.

2.Clip the retaining strap together.

3.Press down on the rear shroud until the two (2) clips secure the rear shroud to the two (2) side shrouds.

2.Remove the rear shroud from the wheelchair. Refer to REMOVING/INSTALLING REAR SHROUD in this procedure of the manual.

3.Perform one (1) of the following:

A.INTEGRATED SLING SEAT MODELS - Fold thewheelchair.RefertoTRANSPORTINGEXCEL in this procedure of the manual.

B.CAPTAIN'S SEAT MODELS - Remove the Captain's Seat from the wheelchair. Refer to REMOVING/INSTALLING CAPTAIN'S SEAT in PROCEDURE 9 of the owner's manual, part number 1080737.

4.HIGH BACK CAPTAIN'S SEAT MODEL WHEEL- CHAIRS ONLY (DETAIL "A") - Remove the phono jack nut that secures the phono jack to the side shroud.

5.Remove the phillips screws, bolts, washers and lock- nuts that secure side shroud and filler to the wheel- chair frame. Refer to FIGURE 14 for phillips screw and washer locations.

6.Remove side shroud and filler from the wheelchair.

7.Repeat STEPS 5-6 for the opposite side of the wheel- chair, if necessary.

27