Invacare P9000 service manual Replacing Batteries, INSTALLING/REMOVING Battery Boxes Figure

Page 33

FWD WHEELCHAIRS

PROCEDURE 8

Battery Charger

Connector (on side

of Wheelchair)

From Battery Charger

NOTE: Position of Battery Charger Connector may vary depending on wheelchair options.

FIGURE 18 - CHARGING BATTERIES

REPLACING BATTERIES

WARNING

Most batteries are not sold with instructions. However, warnings are frequently noted on the cell caps. Read them carefully, otherwise injury or damage can occur.

NOTE: Invacare recommends that both batteries be replaced if one (1) battery is defective.

Recommended Battery Types

WARNING

The warranty and performance specifications contained in this manual are based on the use of deep cycle gel cell or sealed lead acid batteries. Invacare strongly recommends their use as the power source for this unit.

CAUTION

Failure to use the correct battery size and/or voltage may cause damage to your wheelchair and give you unsatisfactory performance.

CHAIR SEAT

QTY

VOLTS

BATTERY

REMARKS

WIDTH

 

 

SIZE

 

 

 

 

 

 

16,18, 20-inches

2

12

22NF

Deep Cycle

 

 

 

 

 

1.Remove the battery boxes from the wheelchair. Refer to REMOVING/INSTALLING BATTERY BOXES in this procedure of the manual.

2.Remove the existing batteries from the battery boxes. Refer to INSTALLING/REMOVING BATTERIES TO FROM BATTERY BOXES in PROCEDURE 7 of this manual.

3.Clean the new battery terminals.

4.Install the new batteries into the battery boxes. Refer to INSTALLING/REMOVING BATTERIES TO/FROM BATTERY BOXES in PROCEDURE 7 of this manual.

Cleaning Battery Terminals

WARNING

DO NOT allow the liquid in the battery to come in contact with skin, clothes or other possessions. It is a form of acid and harmful or damaging burns may result. Should the liquid touch your skin, wash the area immediately and thoroughly with cool water. In serious cases or if eye contact is made, seek medical attention IMMEDIATELY.

NEVER smoke or strike a match near batteries. If the caps of the battery cells are removed, NEVER look directly into them while charging batteries.

1.Examine battery clamps and terminals for corrosion.

2.Verify that the plastic caps are in place over the battery cell holes.

3.Clean the terminals and inside the battery clamps by using a battery cleaning tool, wire brush, or medium grade sand paper.

NOTE: When done, these areas should be shiny, not dull.

4. Carefully dust off all metal particles.

INSTALLING/REMOVING BATTERY BOXES (FIGURE 19)

WARNING

NEVER unplug the battery cables by pulling on the wires. Unplug the battery cables by pulling on the connector ONLY. Otherwise injury or damage may result.

NOTE: To remove the battery boxes from the wheelchair, reverse the following procedure.

1.Verify that the ON/OFF switch on the joystick is in the OFF position.

2.If necessary, remove the Captain's Seat. Refer to REMOVING/INSTALLING CAPTAIN'S SEAT in PROCEDURE 9 of the owner's manual, part number 1080737.

3.If necessary, remove the front and rear shrouds. Refer to REMOVING/INSTALLING SHROUDS in this procedure of the manual.

4.Position the battery boxes onto the battery tray.

NOTE: Make sure the battery cables on the battery boxes are on the same side as the battery connectors on the wheelchair frame.

5.Connect the battery cables from the battery boxes to the battery connectors on the wheelchair frame.

F

W

D

W

H

E

E

L

C H A I R S

33

Image 33
Contents Excel and P9000 E C I a L T E S R N I N GTable of Contents Specifications Specification SI F I C a T I O N S PowerRepair or Service Information Procedure General GuidelinesTroubleshooting Procedure Using Hydrometer to Check Battery Cells Lead Acid FigureBattery Charger Connector Digital Voltmeter Field Load Test FigureProcedure Troubleshooting Motor Testing FigureNumber of Floating Balls Check charging systemPin Motor Connector Ohmmeter Cap MotorCap H O L S T E R Y Replacing Back Upholstery FigureBack Upholstery Washer Phillips Screw Tie Wrap Mounting Hole Locknuts Washer Hex ScrewsAdjusting Back HEIGHT/ Replacing Back Canes Figure Adjusting Seat Depth FigureSeat Frame Procedure A T M EMkiv Joystick Mounting Tube Adjustment Lock Lever Procedure ElectronicsPreparing Mkiv Joystick for USE Figure Repositioning Mkiv Joystick FigureWheels Procedure REMOVING/INSTALLING Drive Wheels FigureInstalling Replacing Pneumatic TIRES/ Tubes Drive WHEELS/CASTERSProcedure Wheels Replacing Casters FigureReplacing Forks Figure Batteries Procedure Battery Terminals/Posts U1 Battery Box Bottom Dual 22 NFT T E R I E S Connecting Battery Cables Dual U1 or Dual 22NF Battery BoxesT T E R Batteries Positive + Battery Terminal/Post Hex Nut Battery Clamp Method Figures 4, 5Battery Clamp CoverPositive + Battery Terminal Post and Battery Clamp RED BatteryR I E S Assembling Excel Refer to Battery Tray in this proce- dure of the manualA I R S Unfolding/Folding Integrated Sling Seat FigureFWD Wheelchairs Adjusting FLIP-UP Removable FootboardUnfolding/Folding Captains Seat Figure Push Brackets Pivot Link CrossbracesReplacing Armrest Pads Figure Replacing Armrest Plate FigureHeight Figure Replacing Captains Seat Figure Steps 3 Steps 7FWD Wheelchairs Procedure Replacing Wiring HarnessSteps 2 Steps 5Limit Switch Phono Plug Body Phono Jack Adjusting Limit Switch FigureREMOVING/INSTALLING Shrouds Filler Side Shroud Battery Box Battery Tray Phono Jack Installing Side Shrouds and FillersPhillips Screws Locknut Retaining Strap16-18 or Changing Seat Width Integrated Sling Seats FigureReplacing Crossbraces Captains Seat Figure Hex Bolts Steps 6 Crossbrace Washer Steps 6 Pivot Link Hex BoltsSpacerLocknut SpacerDescription and Use of Battery Chargers When to Charge Batteries FigureCharging Batteries Figure Required ItemsRecommended Battery Types INSTALLING/REMOVING Battery Boxes FigureCleaning Battery Terminals Replacing BatteriesFolding Battery Tray for Transport Figure Battery TrayUnfolding Battery Tray for Use Figure Changing Width of Battery Tray FigureReplacing Right Battery Tray Hanger Bracket Figure Removing Battery Tray FigureInstalling Battery Tray Figure Replacing Left Battery Tray Hanger Bracket Figure Footboard Mounting Bracket Battery Tray Hanger BracketRepositioning Motors Figure Spacer Hex ScrewRotate battery tray hanger bracket up Users Weight 201 to 250 LBSClutch Handle Replacing Clutch Handles FigurePin Steps 3 Clutch Handle Steps 917, 18 Steps 4Refer to INSTALLING/REMOV ING Footrests or Install Assembling Power 9000 FigureUnfolding/Folding the Wheelchair Seat Rails GuidesBattery Discharge Indicator RWD WheelchairsWait until charging is complete Retaining Strap Clip Connect the battery box retaining strap clip togetherBattery Tray Figure Changing Seat Width Figure14-15, 16-18 H a I R S Adjusting SEAT-TO-FLOOR HeightReassembly DisassemblyPhillips Screws To Controller From MotorsMotor Mount Underside of Motor Mount Plate Alignment Pin Long SocketPlate Alignment Hole Wheelchair Frame Support Tube Motor/GearboxR R a N T Y Limited WarrantyChedworth Way