Invacare P9000 Connect the battery box retaining strap clip together, Retaining Strap Clip

Page 42

PROCEDURE 9

RWD WHEELCHAIRS

R

W

D

W

H

E

E

L

C H A I R S

REPLACING BATTERIES

WARNING

Most batteries are not sold with instructions. However, warnings are frequently noted on the cell caps. Read them carefully, otherwise injury or damage may occur.

NOTE: Invacare recommends that both batteries be replaced if one (1) battery is defective.

Recommended Battery Types

WARNING

The warranty and performance specifications contained in this manual are based on the use of deep cycle gel cell or sealed lead acid batteries. Invacare strongly recommends their use as the power source for this unit.

CAUTION

Failure to use the correct battery size and/or voltage may cause damage to your wheelchair and give you unsatisfactory performance.

3.Clean the terminals and inside the battery clamps by using a battery cleaning tool, wire brush, or medium grade sand paper.

NOTE: When done, these areas should be shiny, not dull.

4. Carefully dust off all metal particles.

INSTALLING/REMOVING BATTERY BOXES (FIGURE 6)

NOTE: To remove the battery boxes from the wheelchair, reverse the following procedure.

1.Verify that the ON/OFF switch on the joystick is in the OFF position.

2.Position battery boxes onto battery tray. Make sure battery cables on battery boxes are on the same side as the battery connectors on the wheelchair frame.

3.Connect the battery cables from the battery boxes to the battery connectors on the wheelchair frame.

4.Connect the battery box retaining strap clip together.

Retaining

 

Strap

Battery Boxes

 

CHAIR SEAT

QTY

VOLTS

BCI STOCK

REMARKS

WIDTH

 

 

NO.

 

14-inches

2

12

U1

Deep Cycle

 

 

 

 

 

16,18, 20-

 

 

 

 

inches

2

12

22NF

Deep Cycle

 

 

 

 

 

NOTE: Charge batteries daily. It is critical not to let them run low at any time.

Cleaning Battery Terminals

WARNING

DO NOT allow the liquid in the battery to come in contact with skin, clothes or other possessions. It is a form of acid and harmful or damaging burns may result. Should the liquid touch your skin, wash the area immediately and thoroughly with cool water. In serious cases or if eye contact is made, seek medical attention IMMEDIATELY.

The use of safety glasses is recommended when cleaning the battery terminals.

NEVER smoke or strike a match near batteries. If the caps of the battery cells are removed, NEVER look directly into them while charging batteries.

1.Examine battery clamps and terminals for corrosion.

2.Verify that the plastic caps are in place over the battery cell holes.

 

Battery Connections on

Retaining Strap Clip

Side of Wheelchair Frame

FIGURE 6 - INSTALLING/REMOVING BATTERY BOXES

WARNING

The Battery Box Retaining Strap MUST be fastened securely and adjusted properly to hold battery boxes in place before using the wheelchair.

5.Connect the battery box retaining strap clip together and adjust if necessary.

42

Image 42
Contents Excel and P9000 R N I N G E C I a L T E STable of Contents Specification S SpecificationsPower I F I C a T I O N SProcedure General Guidelines Repair or Service InformationBattery Charger Connector Digital Voltmeter Using Hydrometer to Check Battery Cells Lead Acid FigureTroubleshooting Procedure Field Load Test FigureNumber of Floating Balls Motor Testing FigureProcedure Troubleshooting Check charging systemPin Motor Connector Ohmmeter Cap MotorCap Back Upholstery Washer Phillips Screw Replacing Back Upholstery FigureH O L S T E R Y Tie Wrap Mounting Hole Locknuts Washer Hex ScrewsSeat Frame Procedure Adjusting Seat Depth FigureAdjusting Back HEIGHT/ Replacing Back Canes Figure A T M EPreparing Mkiv Joystick for USE Figure Procedure ElectronicsMkiv Joystick Mounting Tube Adjustment Lock Lever Repositioning Mkiv Joystick FigureInstalling REMOVING/INSTALLING Drive Wheels FigureWheels Procedure Replacing Pneumatic TIRES/ Tubes Drive WHEELS/CASTERSProcedure Wheels Replacing Casters FigureReplacing Forks Figure Batteries Procedure Battery Terminals/Posts U1 Battery Box Bottom Dual 22 NFT T E R I E S Connecting Battery Cables Dual U1 or Dual 22NF Battery BoxesT T E R Batteries Battery Clamp Battery Clamp Method Figures 4, 5Positive + Battery Terminal/Post Hex Nut CoverPositive + Battery Terminal Post and Battery Clamp RED BatteryR I E S A I R S Refer to Battery Tray in this proce- dure of the manualAssembling Excel Unfolding/Folding Integrated Sling Seat FigureUnfolding/Folding Captains Seat Figure Adjusting FLIP-UP Removable FootboardFWD Wheelchairs Push Brackets Pivot Link CrossbracesReplacing Armrest Pads Figure Replacing Armrest Plate FigureHeight Figure Replacing Captains Seat Figure Steps 7 Steps 3Steps 2 Replacing Wiring HarnessFWD Wheelchairs Procedure Steps 5Adjusting Limit Switch Figure Limit Switch Phono Plug Body Phono JackREMOVING/INSTALLING Shrouds Phillips Screws Locknut Installing Side Shrouds and FillersFiller Side Shroud Battery Box Battery Tray Phono Jack Retaining StrapChanging Seat Width Integrated Sling Seats Figure 16-18 orReplacing Crossbraces Captains Seat Figure SpacerLocknut Washer Steps 6 Pivot Link Hex BoltsHex Bolts Steps 6 Crossbrace SpacerCharging Batteries Figure When to Charge Batteries FigureDescription and Use of Battery Chargers Required ItemsCleaning Battery Terminals INSTALLING/REMOVING Battery Boxes FigureRecommended Battery Types Replacing BatteriesUnfolding Battery Tray for Use Figure Battery TrayFolding Battery Tray for Transport Figure Changing Width of Battery Tray FigureReplacing Right Battery Tray Hanger Bracket Figure Removing Battery Tray FigureInstalling Battery Tray Figure Repositioning Motors Figure Footboard Mounting Bracket Battery Tray Hanger BracketReplacing Left Battery Tray Hanger Bracket Figure Spacer Hex ScrewUsers Weight 201 to 250 LBS Rotate battery tray hanger bracket upPin Steps 3 Replacing Clutch Handles FigureClutch Handle Clutch Handle Steps 9Steps 4 17, 18Unfolding/Folding the Wheelchair Assembling Power 9000 FigureRefer to INSTALLING/REMOV ING Footrests or Install Seat Rails GuidesBattery Discharge Indicator RWD WheelchairsWait until charging is complete Connect the battery box retaining strap clip together Retaining Strap ClipBattery Tray Figure Changing Seat Width Figure14-15, 16-18 Adjusting SEAT-TO-FLOOR Height H a I R SPhillips Screws To Controller DisassemblyReassembly From MotorsPlate Underside of Motor Mount Plate Alignment Pin Long SocketMotor Mount Alignment Hole Wheelchair Frame Support Tube Motor/GearboxLimited Warranty R R a N T YChedworth Way