FWD WHEELCHAIRS | PROCEDURE 8 |
NOTE: If motors are repositioned, the front riggings may need to be repositioned. Refer to ADJUSTING/REPLAC- ING TELESCOPING FRONT RIGGING SUPPORT in PROCEDURE 9 of the owner's manual, 1080737.
FACTORY SETTINGS
MOTOR MOUNTING POSITIONS
SEAT | 16 | SEAT DEPTH |
|
WIDTH | 17 | 18 | |
16 | MIDDLE | MIDDLE | MIDDLE |
18 | MIDDLE | MIDDLE | MIDDLE |
20 | MIDDLE | MIDDLE | MIDDLE |
|
|
|
|
USERS' WEIGHT 200 LBS AND UNDER -
MOTOR MOUNTING POSITIONS
SEAT |
| SEAT DEPTH |
|
WIDTH | 16 | 17 | 18 |
16 | REAR | REAR | REAR |
18 | REAR | REAR | REAR |
20 | REAR | REAR | REAR |
USERS' WEIGHT 201 TO 250 LBS -
MOTOR MOUNTING POSITIONS
SEAT |
| SEAT DEPTH |
|
WIDTH | 16 | 17 | 18 |
|
|
|
|
16 | MIDDLE | MIDDLE | MIDDLE |
18 | MIDDLE | MIDDLE | MIDDLE |
20 | MIDDLE | MIDDLE | MIDDLE |
|
|
|
|
NOTE: The front motor mounting position is reserved for future applications.
1.Remove the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of the manual.
2.Perform one (1) of the following:
A.WHEELCHAIR EQUIPPED WITH
B.
3.Rotate battery tray hanger bracket up.
4.Left side of wheelchair only - Remove the front dust cover from the end of the crossbrace.
NOTE: Left is determined by sitting in the wheelchair.
5.Refer to charts in this procedure to determine the proper mounting position that corresponds to the user's weight.
6.Remove the six (6) socket screws that secure the motor to the wheelchair frame.
7.Position the motor on the wheelchair frame at the position noted in STEP 5 as shown in FIGURE 26.
STEPS 2, 4, 10, 11, 12 | Spacers |
Dust Cover (Not Shown)
Battery Tray
Hanger
Bracket
Hex Screws
Footboard
Mounting
Bracket
LONG Socket Screws (Apply Loctite 242 and
torque to
Wheelchair
Frame
SHORT |
|
Socket Screws |
|
(Apply Loctite |
|
242 and |
|
torque to 60- |
|
inch pounds) | Motor/ |
(STEPS 6, 8) | Gearbox |
NOTE: It is not necessary to disconnect the clutch handle from the motor/gearbox.
FRONT MOTOR
MOUNTING POSITION
MIDDLE MOTOR
MOUNTING POSITION
REAR MOTOR
MOUNTING POSITION
FIGURE 26 - REPOSITIONING MOTORS
F
W
D
W
H
E
E
L
C H A I R S
37