Replacing Right Battery Tray Hanger Bracket Figure

FWD WHEELCHAIRS

PROCEDURE 8

Battery Tray Pin

Battery Tray

Hex Bolts

Locknuts

Battery Tray

Pivot

16-inch Wheelchair

18-inch Wheelchair

20-inch Wheelchair

FIGURE 22 - BATTERY TRAY - CHANGING WIDTH OF

BATTERY TRAY

Battery Tray Hanger Bracket	Washers

Hex Bolts

Locknuts

Battery Tray

FIGURE 23 - BATTERY TRAY - REMOVING/

INSTALLING BATTERY TRAY

Replacing Right Battery Tray Hanger Bracket (FIGURE 24)

NOTE: Right and left is determined by sitting in the wheel- chair.

C H A I R S

Removing Battery Tray (FIGURE 23)

1.Remove the battery boxes from the wheelchair. Refer toINSTALLING/REMOVINGBATTERYBOXESinthis procedure of the manual.

2.Remove the two (2) hex bolts and locknuts that secure the existing battery tray and washers to the battery tray hanger bracket.

3.Remove the existing battery tray from the wheelchair.

Installing Battery Tray (FIGURE 23)

1.Line up the mounting holes in the new/existing battery tray with the mounting holes in the battery tray hanger bracket.

2.Position one (1) of the washers between the battery hanger bracket and the new/existing battery tray.

3.Reinstall one (1) of the hex bolts and washers through the new/existing battery tray, washer and battery tray hanger bracket and loosely tighten with one (1) of the locknuts.

4.Repeat STEPS 2-3 for the remaining washers, hex bolt, and locknut.

5.Tighten the two (2) hex bolts and locknuts.

NOTE: Tighten the Two (2) hex bolts and locknuts until the tray stays up by itself. Over tightening the hex bolts and locknuts will make the battery tray difficult to flip up.

6.Reinstall the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of the manual.

1.Remove the battery boxes from the wheelchair. Refer toINSTALLING/REMOVINGBATTERYBOXESinthis procedure of the manual.

2.Remove the battery tray. Refer to REMOVING BATTERY TRAY in this procedure of the manual.

3.Perform one (1) of the following:

A.WHEELCHAIR EQUIPPED WITH FLIP-UP REMOVABLE FOOTBOARD - Remove the hex screw and spacer that secures the existing right battery tray hanger bracket and footboard mounting bracket to the wheelchair frame.

B.WHEELCHAIR NOT EQUIPPED WITH FLIP-UP REMOVABLE FOOTBOARD - Remove the front hex screw that secures the existing right battery tray hanger bracket to the wheelchair frame.

4.Remove the rear hex bolt that secures the existing right battery tray hanger bracket to the wheelchair.

NOTE: NOTE hex screw size for reinstallation.

5.Remove the existing right battery tray hanger bracket from the wheelchair.

6.Line up the mounting holes in the new battery tray hanger bracket with the mounting holes in the wheelchair frame.

7.Perform one (1) of the following:

A.WHEELCHAIR EQUIPPED WITH FLIP-UP REMOVABLE FOOTBOARD - Reinstall the hex screw and spacer that secures the new right battery tray hanger bracket and footboard mounting bracket to the wheelchair frame. Use Loctite 242 and torque to 156-in/lbs.