Invacare M61, M50, M51 service manual Adjusting Footrest Height, Model PHWH93 Front Riggings

SECTION 8—FRONT RIGGINGS/FOOTBOARD

Removing

1.Push the front rigging release lever inward and rotate the footrest outward.

2.Lift up on front rigging and remove from the wheelchair.

3.Repeat STEPS 1-2 for opposite side of wheelchair.

Telescoping Front Rigging Support

Hinge

Pins

Front Rigging

Release Lever Front

Rigging

Hinge

Plate

FIGURE 8.1 Installing/Removing Front

Riggings

Adjusting Footrest Height

Model PHWH93 Front Riggings

NOTE: For this procedure, refer to FIGURE 8.2.

1.Remove any accessory from the front rigging(s).

2.Remove the front rigging from the wheelchair. Refer to Installing/Removing Front Riggings on page 73.

NOTE: Lay front rigging on a flat surface to simplify procedure.

3.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

4.Reposition the lower footrest to the desired height.

5.Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest support. Tighten securely.

6.Repeat STEPS 1-5 for the opposite side of the wheelchair footrest, if necessary.

7.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/ Removing Front Riggings on page 73.

Locknut	Footrest Support
	Coved Washer
Coved	Hex Bolt
Washer
	Lower
	Footrest

FIGURE 8.2 Model PHWH93 Front

Riggings

Pronto® Series 74 Part No. 1125075