Invacare M50, M51, M61 service manual Replacing Heel Loops, Model PH904A and PHAL4A Front Riggings

SECTION 8—FRONT RIGGINGS/FOOTBOARD

Model PH904A and PHAL4A Front Riggings

NOTE: For this procedure, refer to FIGURE 8.3.

1.Loosen, but DO NOT remove the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary.

Footrest

Support	Locknut
	Lower Footrest

Lug Bolt

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.

FIGURE 8.3 Model PH904A and PHAL4A

Front Riggings

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 8.4.

1.Note the position of hex bolt, coved washers and locknut for reinstallation.

2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

3.Remove the lower footrest.

4.Remove the mounting screw, spacer and locknut that secure the existing heel loop to the lower footrest.

5.Slide the existing heel loop off the lower footrest.

6.Replace heel loop.

7.Reverse STEPS 1-6 to reassemble.

NOTE: When securing heel loop to lower footrest, tighten the mounting screw and locknut until the spacer is secure.

	Footrest Support
Locknut	Hex Bolt
Coved	Mounting
	Screw
Washer
	Spacer
Lower Footrest
	Heel
	Loop
Locknut

FIGURE 8.4 Replacing Heel Loops

Part No. 1125075 75 Pronto® Series