Invacare M61, M50, M51 service manual Special Notes, Signal Word Meaning

Page 8

SPECIAL NOTES

SPECIAL NOTES

Signal words are used in this manual and apply to hazards or unsafe practices which could result in personal injury or property damage. Refer to the table below for definitions of the signal words.

SIGNAL WORD

MEANING

 

 

DANGER

Danger indicates an imminently hazardous situation which,

if not avoided, will result in death or serious injury.

 

 

 

WARNING

Warning indicates a potentially hazardous situation which, if

not avoided, could result in death or serious injury.

 

 

 

CAUTION

Caution indicates a potentially hazardous situation which, if

not avoided, may result in property damage.

 

 

 

NOTICE

THE INFORMATION CONTAINED IN THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE.

WHEELCHAIR USER

As a manufacturer of wheelchairs, Invacare endeavors to supply a wide variety of wheelchairs to meet many needs of the end user. However, final selection of the type of wheelchair to be used by an individual rests solely with the user and his/her healthcare professional capable of making such a selection.

WHEELCHAIR TIE-DOWN RESTRAINTS AND SEAT RESTRAINTS

Wheelchair users should not be transported in vehicles of any kind while in wheelchairs. As of this date, the Department of Transportation has not approved any tie-down systems for transportation of a user while in a wheelchair, in a moving vehicle of any type.

It is Invacare’s position that users of wheelchairs should be transferred into appropriate seating in vehicles for transportation and use be made of the restraints made available by the auto industry. Invacare cannot and does not recommend any wheelchair transportation systems.

WARNING

ALWAYS wear your seat positioning strap. The seat positioning strap is a positioning belt only. It is not designed for use as a safety device withstanding high stress loads such as auto or aircraft safety belts. If signs of wear appear, the belt MUST be replaced IMMEDIATELY.

Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products.

Pronto® Series

8

Part No. 1125075

Image 8
Contents Pronto Series M50 M51 M61 Recommended Tools Reference DocumentsRecommended Tools Document Part NumberTable of Contents Asba Seat ArmsVAN Seat Shrouds and Frame Front RIGGINGS/FOOTBOARDWheels Batteries MotorsElectronics AccessoriesLimited Warranty Wheelchair TIE-DOWN Restraints and Seat Restraints Signal Word MeaningSpecial Notes Special Notes Label Location Asba Typical Product ParametersMedium SEMI-RECLINE Typical Product Parameters Medium Operation Information Controller Settings/Repair or ServiceGeneral Guidelines Immediately Tire PressureBatteries Grounding Instructions Charging BatteriesRain Test Weight TrainingWeight Limitation EMI Information EMI InformationEMI Information All Wheelchairs Safety INSPECTION/TROUBLESHOOTINGSafety Inspection Checklists Troubleshooting SolutionsAdditional Requirements for M61 Wheelchairs WheelsDisplay Description Definition CommentsSPJ Information Gauge Display Diagnostics Diagnostic Codes Diagnostics CodePossible Solution SUB CodeE05 Symptom Probable Cause Solutions Motor/Gearbox/BrakeContamination is found. Refer to Replacing Motor Battery Battery Charger DON’T Checking Battery Charge LevelM61 Only Field Load Test Motor Testing Battery QualityM50 and M51 Wheelchairs Manufactured Before 8/15/05 Turning the Power On/OffWheelchair Operation Using the Joystick to Drive the Wheelchair Turn the power On by pressing the On/Off buttonMovement Action ReverseAdjusting the Speed Using the Horn Using the Horn M50 M51 Wheelchairs Manufactured Before 15/05Elevating the Seat M50/M51 Wheelchairs Manufactured After 8/14/05 and All M61Elevating the Seat SPJJoystick Switches and Indicators On/Off Toggle SwitchSpeed Control Knob JoystickInformation Gauge Display SPJ+ and SPJ+ w/ACC Joystick Switches and Indicators Mode ButtonMode Button On/Off ButtonSpeedometer Speed Control ButtonsService Indicator Arms Removing/Installing Van Seat ArmAdjusting Van Seat Arm Width Adjusting Van Seat Arm Angle Adjusting Van Seat Arm Height Adjustable Height Arms OnlyReplacing Van Seat Armrest Assembly Adjusting Van Seat Arm Height Adjustable Height Arms OnlyRemoving/Installing Flip Back Armrest Removing/Installing Flip Back ArmrestAdjusting the Flip Back Armrest Height Adjusting the Flip Back Armrest HeightAdjusting the Back Angle VAN SeatSemi-Recline Back Angle Fold Down Back AngleAdjusting the Headrest Semi-Recline Only Removing/Installing the Seat AssemblyInstalling RemovingAdjusting Seat Depth Removing/Installing the Seat AssemblyAdjusting Seat Depth Adjusting the Seat Height M50/M51 WheelchairsM61 Wheelchairs Sets of Seat Total Number Length of MountingAdjusting the Seat Height M61 Wheelchairs Adjusting Seat Position on Seat Base Weight Seat Post Inch Standard Limitation Mounting Hole Seat PositionReplacing the Seat Positioning Strap Replacing the Seat Positioning StrapAsba Seat M50/51 Wheelchairs Only Weight Seat Post Seat Depth Limitation Mounting Hole Inch Adjusting the Seat Height M50/51 Wheelchairs OnlyM61 Wheelchairs Removing/Installing the Seat Pan Adjusting the Seat Width Removing/Installing the Seat FrameAdjusting the Seat Position Removing/Installing the Seat FrameRemoving/Installing the Seat Positioning Strap Adjusting the Seat PositionBack Upholstery Height, only new back canes will be neededAsba Seat Asba Seat Back Height HeightAdjusting the Back Angle Adjusting the Back Angle Installing/Removing Front Riggings Front RIGGINGS/ FootboardAdjusting Footrest Height Model PHWH93 Front RiggingsReplacing Heel Loops Model PH904A and PHAL4A Front RiggingsVan Seats Adjusting/Replacing Telescoping Front Rigging SupportsRaising/Lowering Elevating Front Riggings Position Asba SeatFront Rigging Standard Inch OUT Inches OUT Removing/Installing the Footboard Assembly Adjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Angle DepthWheels Replacing the Front/Rear CastersAdjusting Caster Assembly Adjusting Caster AssemblyRemoving/Installing the Front/Rear Caster Assemblies Removing/Installing the Front Headtube AssemblyRemoving the Drive Wheel Removing/Installing the Drive WheelInstalling the Drive Wheel Removing/Installing the Drive Wheel Inner Rim Removing/Installing the Top Shroud Shrouds and FrameRemoving/Installing the Side Shrouds Removing/Installing the Top ShroudRemoving/Installing the Front Shroud Removing/Installing the Side ShroudsRemoving/Installing the Inner Shrouds Removing/Installing the Front ShroudRemoving/Installing the Pivot Tube Removing/Installing the Inner ShroudsRemoving/Installing the Pivot Tube Removing/Installing the SureStep Spring Removing/Installing the Walking BeamRemoving/Installing the Elevate Actuator Removing/Installing the Walking BeamInstalling Removing/Installing the Elevate Actuator Removing/Installing the Actuator Switch Sensor Batteries Using the Proper Batteries Removing/Installing Batteries from/into Battery TrayBatteries Tool QTY Comments Connecting/Disconnecting Battery Cables Connecting Battery Cables102 Connecting/Disconnecting Battery Cables Disconnecting Battery Cables Charging BatteriesBattery Charger Operation On-Board Battery Charger ON/OFF Indicator Status Charging Indicator StatusReplacing the On-Board Battery Charger Fuse Replacing the On-Board Battery Charger Replacing the On-Board Battery Charger Fuse110 Replacing the On-Board Battery Charger Removing/Installing the Motor MotorsRemoving/Installing the Motor Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverRemoving/Installing the Motor Release Lever Removing/Installing the Motor Release LeverReplacing Motor Brushes 117 Electro-Mechanical Parking Brake Testing Replacing Motor BrushesElectro-Mechanical Parking Brake Testing Removing/Installing the Joystick ElectronicsRepositioning the Joystick Mounting Bracket Van SeatRepositioning the Joystick Mounting Bracket Connecting Disconnecting/Connecting the JoystickDisconnecting Adjusting the Quad-Link Retractable Mount Adjusting Lock/Release TensionAdjusting Lock/Release Tension Replacing the ControllerReplacing the Controller Wire Routing Wire RoutingAccessories Installing/Removing the Crutch/Cane HolderInstalling/Removing the Oxygen Holder HolderUsing the Walker Holder Installing/Removing/Using the Walker HolderInstalling/Removing the Walker Holder Limited Warranty 131USA
Related manuals
Manual 2 pages 51.97 Kb Manual 2 pages 41.81 Kb