SECTION 11—BATTERIES
Using the Proper Batteries
NOTE: For this procedure, refer to FIGURE 11.1.
1.Place battery on ground/flat surface.
2.Visually draw a horizontal and vertical centerline through the middle of battery (FIGURE 11.1).
3.Position the battery so that the terminals are above the horizontal centerline.
4.Visually inspect the battery to ensure the correct position of the POSITIVE and NEGATIVE terminals (FIGURE 11.1).
WARNING
Batteries with terminal configuration as shown below MUST be used. Batteries that have the reverse terminal configuration MUST NOT be used - otherwise injury and damage may occur.
Use This Configuration | DO NOT Use | ||
|
|
|
|
| NEGATIVE |
|
|
| POSITIVE (+) | ||
| Battery Terminal |
| Battery Terminal |
|
|
|
|
|
|
|
|
NEGATIVE
Battery Terminal
U1 Battery | POSITIVE (+) | U1 Battery |
| Battery Terminal | |
|
|
FIGURE 11.1 Using the Proper Batteries
Removing/Installing Batteries from/into Battery Tray
WARNING
ALWAYS use the battery handle when lifting the battery. It is the most convenient method and assures that the battery acid will not spill. It also helps to prolong the life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
Part No. 1125075 | 99 | Pronto® Series |