Invacare 1125078 service manual Removing/Installing the Footboard Assembly

SECTION 4—FOOTBOARD ASSEMBLY

SECTION 4—FOOTBOARD

ASSEMBLY

WARNING

After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the off position.

DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair, make sure that the flip-up footboard is in the upward position.

Limited clearance between footboard and caster - The user’s feet MUST remain on the footboard while operating the chair. If the user’s feet are allowed to rest off the side of the footboard they may come in contact with the caster possibly resulting in injury.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 4.1.

Removing

1.Remove the two mounting bolts that mount the footboard assembly to the base frame.

2.Remove the footboard assembly from the base frame.

Installing

1.Align the footboard assembly with the adjustment holes in the base frame.

2.Install the footboard assembly using the two mounting bolts and locknuts.

Base Frame

Adjustment

Holes

Locknuts	Mounting
	Bolt

Mounting

Bolt

Footboard

Assembly

FIGURE 4.1 Removing/Installing the

Footboard Assembly

Adjusting Footboard Assembly Height

NOTE: For this procedure, refer to FIGURE 4.1.

1.Remove the footboard assembly. Refer to Removing/Installing the Footboard Assembly on page 30.

2.Align the footboard assembly to one of three desired adjustment holes on the base frame.

3.Attach the footboard assembly to the base frame with two mounting bolts and locknuts. Securely tighten.

At’m and At’m QT 30 Part No. 1125078