Invacare 1125078 service manual Multi-Function Charger Port

SECTION 8—BATTERIES

Charger Plugged Into the Joystick

NOTE: For this procedure, refer to FIGURE 8.7.

NOTE: The charger port located on the front of the joystick requires the use of an independent charger. The independent charger is supplied with the wheelchair.

1.Attach the battery charger connector to the charger port on the front of the joystick.

2.Plug the charger’s AC power cord or extension into the grounded 110-volt wall outlet.

3.When charging is complete, turn charger off.

4.Disconnect output cable from joystick charger port.

Multi-Function

Charger Port

FIGURE 8.7 Charging Using an

Independent Charger - Charger Plugged Into

the Joystick

Charger Plugged Directly to Batteries - At’m Only

NOTE: For this procedure, refer to FIGURE 8.8.

1.Disconnect the RED and BLACK connector from the wheelchair harness.

2.Connect 3-pin charger connector to the female 3-pin connector on the charger jumper cable (supplied).

3.Connect RED and BLACK connector on the charger jumper cable to the RED and BLACK connector on the battery pack.

4.Plug the charger’s AC power cord into the grounded 110-volt wall outlet.

5.When charging is complete, turn charger off.

6.Disconnect the charger jumper cable from the battery pack.

7.Reconnect the RED and BLACK connector from the battery pack to the wheelchair harness.

AC Power Cord Plug into Wall Outlet

Charger Jumper Cable

Independent

Charger

RED and	Battery
	Pack
BLACK Battery
Connectors

3-Pin Charger	Female 3-Pin
Connector	Connector

FIGURE 8.8 Charging Using an Independent Charger - Charger Plugged Directly to Batteries

- At’m Only

Part No. 1125078 53 At’m and At’m QT