Invacare 1125078 Adjusting Footrest Height, Installing/Removing the Front Rigging Assembly

Page 66

SECTION 10—FRONT RIGGINGS

Removing

1.Push the front rigging release lever inward while rotating the front rigging assembly outward.

2.Lift the front rigging assembly out of the front rigging support bracket.

3.Repeat STEPS 1-2 for the other front rigging assembly, if necessary.

 

Mounting Pin

Seat Frame Tube

Front Rigging

 

 

Assembly

Inside of

Outside of

Wheelchair

Wheelchair

Front Rigging

Release Lever

Footrest

Front Rigging

Support Bracket

FIGURE 10.2 Installing/Removing the Front Rigging Assembly

Adjusting Footrest Height

NOTE: For this procedure, refer to FIGURE 10.3.

1.Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 65.

2.Remove the hex screw and coved spacer.

3.Move the footrest with slide tube up or down on its mounting tube until the desired footrest height is achieved.

4.Install the hex screw and coved spacer through the front rigging upper support and the slide tube. Securely tighten.

5.Install the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 65.

6.Repeat STEPS 1-5 for the other side, if necessary.

Hex

Front Rigging

Screw

Upper Support

Slide

Tube

Coved

Spacer

Footrest

FIGURE 10.3 Adjusting Footrest Height

At’m and At’m QT

66

Part No. 1125078

Image 66
Contents At’m and At’m QT Reference Documents Reference DocumentsWheelchair Type Electronics Manual Table of Contents Joystick Table of ContentsArms BatteriesTransporting the Wheelchair Limited Warranty ANTI-TIPPERSSignal Word Meaning Special NotesWheelchair TIE-DOWN Restraints and Seat Restraints Label Location At’mAt’m QT Typical Product Parameters Typical Product ParametersParameters Repair or Service Information General GuidelinesTire Pressure Operation Information OxygenBatteries Charging Batteries Grounding Instructions Weight TrainingWeight Limitation Rain TestEMI Information EMI InformationEMI Information Safety INSPECTION/TROUBLESHOOTING ChecklistWheels Solutions TroubleshootingInformation Gauge and Diagnostics Codes WheelsDisplay Description Definition Comments Diagnostics Code Possible SolutionSUB Code E05 E08 Symptom Probable Cause Solutions Motor/Gearbox/BrakeDamaged connector or worn Down, and recharge the wheelchair overnight with Troubleshooting Battery Troubleshooting Battery Charger Checking Battery Charge Level Field Load TestDON’T Battery Quality Field Load TestElectro-Mechanical Parking Brake Test Electro-Mechanical Parking Brake TestAdjusting Footboard Assembly Height Footboard AssemblyRemoving/Installing the Footboard Assembly InstallingRemoving/Installing the Seat SeatRemoving/Installing the Seat Replacing Seat Positioning Strap Replacing Seat Positioning StrapRemoving/Installing Under-Seat Basket Removing/Installing Seat UpholsteryRemoving/Installing Seat Upholstery Replacing the Seat Latches Replacing the Seat LatchesRemoving/Installing Arm Pads ArmsRemoving/Installing Arm Pads Replacing Clothing GuardRemoving/Installing Arm Tube Removing/Installing Arm TubeConnecting Disconnecting/Connecting the JoystickDisconnecting JoystickRemoving/Installing the Joystick JoystickRemoving/Installing the Joystick Repositioning the Joystick to Opposite Arm Recommended Battery Type BatteriesRemoving/Installing the Battery Pack on the At’m Recommended Battery TypeRemoving/Installing the Battery Box on the At’m QT Removing/Installing the Battery Pack on the At’mRemoving/Installing the Battery Box on the At’m QT Negative Black Removing Removing/Installing the At’tm QT Battery Box Assembly Removing/Installing the At’tm QT Battery Box Assembly Charging Using an Independent Charger Charging BatteriesMulti-Function Charger Port Resetting the Circuit Breaker At’m10 Resetting the Circuit Breaker At’m At’m QTMotors Engaging/Disengaging the MotorsRemoving/Installing Motor Shroud Removing/Installing Motor ShroudRemoving/Installing the Base Plate Removing/Installing the Base PlateRemoving/Installing MK5 Controller Removing/Installing MK5 ControllerRemoving/Installing the Motors Removing/Installing MK5 Controller InstallingRemoving/Installing the Motors Replacing the Knurled CylinderMotors Replacing the Knurled Cylinder Installing/Removing the Front Rigging Support Brackets Front RiggingsInstalling/Removing the Front Rigging Assembly Front RiggingsAdjusting Footrest Height Installing/Removing the Front Rigging AssemblyWheels and Casters Replacing Front CastersAdjusting Forks Replacing ForksRemoving/Installing the Drive Wheels Replacing Forks Adjusting ForksRemoving/Installing the Drive Wheels Replacing Drive Wheels on the Drive AxleRemoving/Installing the Anti-Tippers ANTI-TIPPERSRemoving/Installing the Anti-Tippers- At’m Removing/Installing the Anti-Tippers- At’m QT Transporting the Wheelchair Transporting the WheelchairTransporting the Wheelchair Limited Warranty USA