Invacare 1125078 service manual Negative Black

SECTION 8—BATTERIES

Installing

1.Install the batteries into the battery pack in the orientation shown in FIGURE 8.4.

2.Connect the wiring harness to the batteries in the following order -

A.NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal on the left battery.

B.POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post on the right battery.

C.WHITE battery cable (jumper) to the POSITIVE (+) battery terminal/post on the left battery and the NEGATIVE (-) battery terminal/post on the right battery.

3.Slide the red and black battery connector out of the battery pack in the slit provided on the front flap.

4.Close the battery pack by performing the following -

A.Fold down the front flap and press to engage the hook and loop straps.

B.Fold down the side flaps and press to engage the hook and loop straps.

NOTE: Ensure that the hook and loop straps are securely fastened before lifting the battery pack.

5.Install the battery pack on the wheelchair. Refer to Removing/Installing the Battery Pack on the At’m on page 45.

Left

Battery

DETAIL “A” - BATTERY WIRING

NEGATIVE BLACK

Right

Battery

Front

Battery Cable RED and BLACK

Battery Connector

NEGATIVE

Side Flap

Flap

Side Flap

Terminal

POSITIVE RED

Battery Cable

Circuit

Breaker

POSITIVE

Slot

Battery Pack

POSITIVETerminal Terminal

NEGATIVE

Terminal

Left

Battery

Right Battery

FIGURE 8.4 Removing/Installing the Batteries From/Into the At’m Battery Pack

At’m and At’m QT 48 Part No. 1125078