Adcom A723, A720 manual Replacing the fuse, Conﬁguring the software

Page 12

12

CHAPTER 2

Using the Base Station

Note: The serial cable ends are identical, so it doesn’t matter which you use in each location.

3.Plug the appropriate ends of the power cord into the power supply and the power source (outlet).

Figure 3 shows the base station conﬁguration.

Figure 3. Base Station Conﬁguration

Replacing the fuse

Should you need to replace the fuse, simply remove the old fuse from the power supply and insert a new 250 mA 250 V fuse.

Conﬁguring the software

This manual details hardware installation only. Refer to the addVANTAGE 4.1 Lite Reference Manual for instructions about using addVANTAGE Lite software.

If you are experienced in technical software issues, you can also perform some conﬁguration with the receiver by using a terminal window. See “Conﬁguring the devices” on page 24 for these instructions.

Image 12

Contents ADC N ADC N Contents Contents Introduction What are addIT devices?Installation issues Conventions ItalicsChapter Using the Base Station Opening the packagesInstalling the base station Installing the receiverInstalling the power supply AddIT Power SupplyReplacing the fuse Conﬁguring the softwareUsing the RTU Installing the RTU Shows an addIT RTUShows what a typical RTU ﬁeld installation looks like More about the LED tool RTU battery Maintaining and servicing the RTUConﬁguring an addIT RTU in the addVANTAGE software Changing the battery Chapter Chapter Performing Advanced Functions Understanding connectors Receiver connectorDevice series RTU connectors Pins on an I/O Connector Top ViewAddIT RTU Power Connector Top View Conﬁguring the devicesGeneral format of a command Serial communication protocolGeneral format of an answer Using terminal commands Series 1 devicesSET Ownid nnnn SET Ownid SET PMP bl bhSET PMP 63 SET Slot 3600SET Freq freq step SET Freq 467112500SET Rssi value Querying the actual conﬁguration parameters SET RssiSeries 2 and 3 devices CmdsFreq Freq 433925000Freq Freq 433925000 25000Slot PMP PMP 65 72 193 cm193 CM 1 SSTDEV ReplRepl 5667 DELDEL Data 5666 12/12/1998 Data b1 b2 b3 ... bnDd mm yyyy hh mm ss si ft d1 d2 ... dn dd mm yyyy Dn csFrame 38 description Data 6367 30/4/1999 Frame 39 descriptionData ImmeRoute Fdev InfoTemp = internalTem p Info 255 0 18/4/1999 21511 1.3 0 0 0 91 146 900Anlg Code Description Parameters Returns Sampling methods are deﬁned by three bits, as follows Return result depends on the control byte see table. However A720B and A723, but see also the comments in Remote on Performing Advanced Functions Command Code Deﬁnitions Port 6789 Port 7/5/1999 183422 193 RX193 TX 6789 B #234 BA#7851 BA 15190 BBlst 30/8/2001 160341 VERVER 1.3 VER 2.0Notiﬁcations Returned errors list Command line interpreterDevice descriptors and storage handler Real time clockNotiﬁcations Chapter Appendix. Speciﬁcations Parameter Min Typ Max UnitTransmitter all measurements made on a 50 Ω resistive load Chapter Chapter Index INFO, 41 OWNID, 26 PMP PMP What a base station contains Xmit Credits and Colophon CreditsColophon