6.Install the blower motor box assembly to the opposite side (rear) of the vent box with the vent located in the bottom venting position. Place the bottom tab of the blower into the bottom mounting channel.
9.Reinstall panel to front side of vent box panel. Place bottom tab of the panel into the bottom mounting channel.
B
A
A. Blower box
B. Bottom mounting channel
7.Plug in the wire connector to the blower motor.
AB
A.Blower motor
B.Wire connector
8.Tilt blower box top tab so it is flush with the vent box panel and position it under the top mounting bracket. Slide bracket into the “Z” slots and tighten the 2 hex/slotted head screws to secure.
B
A
A. Blower mounting channel
B.Panel
10.Tilt panel top tab so it is flush with the vent box panel and position it under the tip mounting bracket. Slide bracket into the “Z” slots and tighten the 2 hex/slotted head screws to secure.
11.See “Complete Installation - Interior Mounted Motor” section.
Complete Installation
(Interior Mounted Motor)
1.Attach backdraft damper over 6" (15.2 cm) vent extension. Secure with vent clamp.
B
A
A. 6" (15.2 cm) vent extension
B. Backdraft damper
14