Check Operation
1.Remove the vent filter shipping bracket screws and bracket.
A
B
A. Vent filter shipping bracket
B. Screws
For information on ordering, see the “Assistance or Service” section.
B
A
C
E
D
A. Top trim
B. ON/OFF button
C. Blower control slider
D. End cap
E. Filters
2.Push and hold the button on the top of the downdraft vent for a few seconds. The retractable section of the downdraft vent will rise, and the blower will start. Position the top trim over the retractable section and snap trim into place.
Trim kits for matching your cooktop color are available from your dealer.
3.Slide the control slider on the side of vent to check the operation and speed of the blower.
4.If the blower does not operate:
■Check that filter or filters are pressed in as far as they will go.
■Check that the circuit breaker has not tripped or a household fuse blown.
■Check downdraft vent fuse located under power board.
5.Connect vent system to blower. Vent system must end with a wall or roof cap. Use clamps to seal all joints.
6.Install cooktop according to manufacturer’s instructions. Check that rear of cooktop overlaps edge of retractable downdraft vent by ³⁄₈" (9.5 mm). See “Countertop Cutout Dimensions” in the “Location Requirements” section.
NOTE: To get the most efficient use from your new retractable downdraft vent, read the “Vent System Use” section.
INSTALLATION INSTRUCTIONS
EXTERIOR-MOUNTED VENT MOTOR
IMPORTANT: Exterior blower Model Number KPEU722M | Island location - rear vent |
[1200 cfm (34.0 m3/3)] cannot be used with this retractable |
|
downdraft vent system. |
|
NOTE: |
|
blower system, Model Number KPEC992M [900 cfm (25.5 m3/m)], |
|
available from your dealer or authorized parts supplier. |
|
|
|
Venting Methods
Determine which venting method is best for your application. Vent system can terminate through either the wall or roof.
Island location - front vent
16