7.Connect the 2 white wires together using UL listed wire connectors.
8.Connect the 2 black wires together using UL listed wire connectors.
9.Tighten conduit connector clamp screws.
10.Replace the terminal box cover and secure with screw.
11.Reconnect power.
Check Operation
1.Remove the vent filter shipping bracket screws and bracket.
A
B
A. Vent filter shipping bracket
B.Screws
2.Push and hold the button on the top of the downdraft vent for a few seconds. The retractable section of the downdraft vent will rise. The blower will start immediately if the blower control knob is set to an “on” position.
3.Position the top trim over the retractable section and snap trim into place.
Trim kits for matching your cooktop color are available from your dealer.
For information on ordering, see the “Assistance or Service” section.
B
A
C
E
D
A. Top trim
B. ON/OFF button
C. Blower control slider
D. End cap
E. Filter or filters depending on model
4.Slide the control slider on the side of the vent to check the speed of the blower.
If the blower does not operate:
■Check that filter or filters are pressed in as far as they will go.
■Check that circuit breaker has not tripped or a household fuse blown.
■Check downdraft vent fuse located under power board.
5.Connect vent system to 10" (25.4 cm) round vent collar plate.
Position vent to avoid wall studs and floor joists. Complete all vent work. Use clamps to seal all joints.
Vertical vent for
6.Install cooktop according to manufacturer’s instructions. Check that rear of cooktop overlaps edge of retractable downdraft vent by ³⁄₈" (9.5 mm). See “Countertop Cutout Dimensions” in the “Location Requirements” section.
NOTE: To get the most efficient use from your new retractable downdraft vent, read the “Vent System Use” section.
21