14. OPERATING PROCEDURES
14.1 WEIGHING OPERATION
14.1 WEIGHING OPERATION
Menu: REG., M. DOWN, or REWRAP
Mode: WEIGH
The weigh mode is used to weigh a commodity and to issue the label. The label contains data such as a weigh, unit price (price per weight) and total price (calculated as a result of the weighing operation). The following is a basic operation seen at the sales floor of a store or at a back room where different kinds and weights of commodities are repacked. Pressing the VOID key subtracts the last entry from the memory.
Example) When PLU #100 and an unit price of $8.00 are set in the speed key #12.
|
|
|
|
|
|
Enter the PLU #. | 1 | 0 | 0 |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Press: PLU
LB |
kg |
Press the | 12 |
speed key. |
|
The unit of measure can be changed for CA model only.
LB ↔ kg
Available only when the initial | Remote Display |
|
|
| ||||
WEIGHT | UNIT PRICE | TOTAL PRICE | ||||||
setting # | ||||||||
| ||||||||
|
|
|
|
| 1.000 | 8.00 | 8.00 | |
kg scale |
| lb scale |
| |||||
|
|
|
|
| ||||
|
|
|
|
|
|
| ||
|
|
|
|
|
| REG |
100 g | 1/4 | 1/2 | Liquid Crystal Display | |||
Place a commodity |
|
|
|
| ||
on the platter. |
|
|
|
|
| |
(Ex. 1.000 lb.) |
|
|
|
|
| |
|
|
|
|
|
| PACKED ON |
MANUAL: | PRT |
| : AUTO |
| SELL BY | |
|
|
| ||||
* |
|
|
| |||
|
|
|
|
|
| |
|
|
| The label is issued. | NET WT. | PRICE lb | |
|
|
|
|
|
| TEC STORE |
Press when canceling |
|
| (TEL) | |||
VOID |
| (Sample label) | ||||
the last sales. |
|
| ||||
NOTES: 1. Pressing a speed key to which no PLU data has been assigned will result in an error. In this case, press the C key, then press a speed key to which PLU data has been assigned.
2.To change between AUTO and MANUAL, follow the procedure provided in section 14.9.
3.If a unit price exceeding 4 digits is obtained by multiplying by 2 or 4 (when pressing the 1/2 lb key or 1/4 lb key), the unit price will be 0.
4.
100 g key is available only when the scale is a kg scale or operated on kg base.
This key, however, has no function on the AU type.
5.When the 1/2 lb , 1/4 lb or 100 g key is pressed, the unit price will change on the display. The 100 g key, however, has no function on the AU type.
6.When the “compulsory tare” is selected, a tare must be subtracted in a weighing operation, otherwise an error message “TARE REQUIRED” will be displayed when the following operation has been done:
Manual mode: Pressing the PRT/* key
Auto mode: Placing a commodity on the platter.
Floating vendor mode: Pressing the Vendor key.
When a “TARE REQUIRED” is displayed, refer to Section 14.6 to follow the proper weighing procedure.