Toshiba SL-9000-LSB owner manual CMT Operation Mode, LON System Mode

16. ERROR MESSAGE TABLE

16. ERROR MESSAGE TABLE

CMT Operation Mode

Message				Cause			Solution
			Mismatch of the model type.
			Mismatch of the base unit.
MISMATCH SPEC.
			Mismatch of the VERSION.		Press the		CLEAR	key.
			Mismatch of the TRANS-
			MITTING DATA.
			Mismatch of the scale
			capacity.
			Parity error
			Framing error
			Overrun error
BAD TAPE OR CMT					Press the		CLEAR	key.
			Data error
			Two or More Hardware error
TIME OUT ERROR			Time out error		Press the		CLEAR	key.
LON System Mode
Error message				Cause		Solution			B BM/S
COMMUNI.	1.	The power of the master or backup			1.	Turn the power of the master
ERROR		master scale is not turned ON.				or backup master scale ON.
		They are not connected with each				Connect them with each other
		other or in off-line state.				or turn the scale in-line.
	2.	LON cable is broken.			2.	Call your authorized service
						representative.
SEQUENCE	The power was not turned OFF and				Turn the power switch OFF and
ERROR	ON again after setting ID #.				ON again.
SEQUENCE #	Text data number is incorrect.				Call your authorized service
ERROR					representative.
MASTER BUSY	Registration job is performed on a				1.	Quit reset job on the master
	satellite scale while reset job is per-					scale.
	formed on the master scale.				2.	Quit registration job on the
						satellite scale.
BM NOT RESET	The backup master does not have				Down load PLU from the master
	same PLU with the mater scale.				to the backup master scale.
					Then run the reset operation
					again.
TEXT ERROR ##	1.	Error text is found.			Call the TOSHIBA TEC autho-
		02:		Sequence No. error	rized service representative.
		05:		LRC error
		08:		Text error

09:Command error

2.The master scale differs from other scale in ROM version.

M: Master scale BM: Backup master scale S: Satellite scale

16-3