Toshiba H-9100N-CA, EO1-32003BE Speed KEY Setting, Setting Department/Vendor Number, ESC Menu

10. PROGRAMMING PROCEDURES

10.10 SPEED KEY SETTING

10.10 SPEED KEY SETTING

Menu Page: 1

Item No.: 9

The H-9100N has a maximum of 108×2 speed keys which are very convenient to call PLUs quickly. (Refer to page 5-3 regarding the Key Layout.)

<MENU>

Page 1

i

9

◇

Toggles the speed key Page

Enter the Speed

Key number

(# 1 to 108 on each page)

NEXT or

PLU

ENTER

Enter the PLU#.

(max. 6 dig.)

ENTER

i

PROG.

ESC.

<MENU>

Page 1

Main

<MENU>

■Setting Department/Vendor Number

<MENU>	9
Page 1
	AUTO	Enter the default	ENTER
	CODE department #. (1 to 99)

Enter the speed

key number.

ENTER	◇	Enter the department # 1
		to 99 or vendor # 0 to 39.

Selecting items to be assigned to speed keys.

(PLU #/VENDOR #/DEPT #/)

ENTER

PROG.

ESC.

<MENU>

Page 1

Main

<MENU>

●Department Number

When initial set #10-6 is set to “1”, the six-digit PLU # is divided into two; the upper two digits are assigned to department #, and the lower four digits to PLU.

The department # is automatically added in the front of the four-digit PLU # and treated as a six-digit PLU #.

In case of “PROG.”, “Report”, and “Reset” modes, PLU # is treated as a six-digit number. So the upper two digits are not treated as department #. Consequently the four-digit PLU # is available only in “REG.”, “M.DOWN”, and “REWRAP” modes.

NOTE: The default Dept No. is a two- digit serial number ranging from o to 99. Entering a “0” clears a Dept. No.

●Vendor Number

Vendor numbers can be be set when the Initial Setting #11-1 is set to 1.

Vendor numbers are assigned to the speed keys in two ways:

①Individual vendor number: 00-39

Vendor # is assigned to the speed keys one by one.

②Group vendor number: 0-, 1-, 2- and 3-

Maximum 10 vendor numbers can be assigned to one speed key, resulting in 4 speed keys in total. When assigning group vendor numbers to the speed keys, enter the first digit of the vendor key (0, 1, 2 or 3) plus a bar (-).

10-17