Toshiba EO1-32003BE, H-9100N-CA, H-9100N-US owner manual PL-3 Operation

10. PROGRAMMING PROCEDURES

10.13 CMT/PL-3

■PL-3 Operation

Connect the PL-3 to the H-9100N by using RS-232C Cable, then turn on the power of the H- 9100N and the PL-3.

Insert a data disc into the PL-3 and adjust the transmission rate to the H-9100N ( 7 2 :4800 BPS

or		7		3		: 2400 BPS) by using the rotary switch.
							SAVE
Press the								key of the PL-3, then check whether the SAVE LED is on.
Program the file number of the data disc by using the rotary switch.
(	4		1		: File No. 1,				4	2	: File No. 2,	4	8	: File No. 8,	4	9	: File No.9)

<MENU>

Page 2

NOTES:

2

Set the transmission item.

(Refer to table 4)

NEXT	or
PLU

SAVE

or

LOAD

ENTER

PROG.

ESC.

<MENU>

Page 2

Main

<MENU>

1.	Press the		SAVE	or the	LOAD	key on the PL-3.
2.	In the	ENTER		Key is not pressed within 10 seconds after the			SAVE	or the	LOAD	key is
	pressed, a Time Out Error results.

3.After pressing the ENTER key, the operation ends when “00” appears in the 7 seg. display and LAMP goes off. Remove the data disc and turn the power off.

4.Be sure to start the PL-3 before the main operation.

■Table 3: Error code for PL-3 operation

Error Code		Error Message
	0	FDC ERROR
	1	FDK MISINSERTION ERROR
	2	UNAVAILABLE FDK INSERTION
		ERROR
1	3	VOL. LABEL UNMATCH ERROR
	4	FDK MEMORY FULL ERROR
	5	WRITE PROTECT ERROR
	6	NO SEARCH FILE ERROR
	1	TIME OUT ERROR
	2	LOAD ERROR
3
	3	FDK ERROR
	4	BUSY STATUS
	5	POWER FAIL ERROR
	6	OVERRUN ERROR

Error Code		Error Message
3	7	FRAMING ERROR
	8	PARITY ERROR
	0	DATA ERROR
	1	STATUS ERROR
7
	2	TIME OUT ERROR
	3	FDK READ/WRITE ERROR
	F	DESIGNATED SELECT KEY
		ERROR
	0	RAM READ/WRITE ERROR
	1	ROM CRC ERROR
8
	2	RAM BACK UP BATTERY ERROR
	3	FDC DIAG LEVEL 0 ERROR
	E	SYSTEM FDK LOADING ERROR
	F	SYSTEM ERROR

1)When the error code is FF, this system enters stop mode. (Turn the power off/on for release.)

2)When the error code is F2 or FE, perform the status clear ( 9 9 ).

3)If an error occurs, refer to the PL-3 Owner’s Manual to solve the problem.

10-21