Toshiba H-9100N-CA, EO1-32003BE, H-9100N-US owner manual Print Format, By pressing Key

10. PROGRAMMING PROCEDURES

10.11 PRINT FORMAT

10.11 PRINT FORMAT

Menu Page: 2

Item No.: 0

The H-9100N can memorize 5 different print formats. After the print formats are set, you can call them by pressing the print format number.

<MENU>

Page 2

0

Select the print format # which allocates the label format #

by the NEXT PLU key or key.

Enter the label format #. (Refer to table 2)

CHANGE

PLU

	On-demand
Issue method
Batch	Select “SENSITIVITY ADJUST”		SET
	by pressing the	◇ key.	NEXT
	When Batch Printing with backing paper is
	selected, the sensitivity of the label sensor will be
	set by pressing the	SET NEXT key before
	issuing label.

FEED

j
	Is print	Correct
TEST	position
	correct?

Incorrect

Select the Item for adjustment.

1gradation =0.154 mm (1 dot)

1 gradation

=0.462 mm (3 dots)

1 gradation

=0.462 mm (3 dots)

Only when using the bar code change label with pre-feed area. (This adjustment cannot be made on the Variable Length Label.)

◇

Enter the correct label feed value.

(Range: 0 to 199)

Enter the correct value for commodity name position. (Range: 0 to 9)

Enter the correct value for address position.

(Range: 0 to 15)

Enter the correct value for pre-feed area.

(Range: 0 to 65)

ENTER

ENTER

ENTER

ENTER

j

j

j

j

CHANGE

PLU

<MENU>	PROG.
Page 2

Main <MENU> ESC.

NOTES:

1.When a commodity name position is adjusted, an address position will move automatically.

2.When entering the other label format #, fine adjust values are initialized.

3.Selecting label format numbers other than those provided in Table 2 results in an error.

4.When selecting a variable length label format, rectangles are printed instead of print items in the case of the test printing.

5.Pressing the ◇ key allows you to select a print format number from 1 to 5.

6. Be sure to press the SET NEXT key when a label format for batch printing with backing paper is selected.

10-18