Digi installation manual 10.11 DC-190 Ultra Count Speciﬁcations

Page 32

10.11 DC-190 Ultra Count Speciﬁcations

Power

Power source	100–120VAC or 220–240 VAC at
	50/60 Hz
Power consumption	20 W

Analog Speciﬁcations

Input sensitivity	0.40–4.00 mV/V
Zero adjustment range	100% FS
A/D conversion rate	10/sec
Load cell excitiation	12V DC
Load cells per scale	4 x 350Ω
Load cell connectors	2 x 14-pin Amphenol
Scale channels	Up to four: three analog (load cell)
	scales, plus one force balance
Weightdisplay resolution	1/10000, 1/5000, 1/2500
Counting resolution	1/1000000

Digital Speciﬁcations

Weight display	5 digits
Unit weight display	5 digits
Quantity display	7 digits
Item memory	200 items, expandable with IMS
	software

Serial Communications and Setpoint Connectors

SCANNER port	8-pin DIN, RS-232C
FORCE BALANCE port	8-pin DIN, RS-232C
232C/PRINTER port	9-pin D-Sub, RS-232C
Setpoint output	8-pin mini-DIN, 24V open collector

Environmental

Operating temperature	14°F to 104°F (–10°C ° to 40°C)
Operating humidity	10% – 80% relative humidity

Physical

Bench type	16.4 in (W) x 17.1 in (D) x 4.9 in (H)
	41.7 cm (W) x 43.4 cm (D) x 12.4 cm (H)
	17.6 lb (8.0 Kg)
Pole type	16.4 in (W) x 16.5 in (D) x 17.9 in (H)
	41.7 cm (W) x 41.9 cm (D) x 45.5 cm (H)
	19.4 lb (8.8 Kg)

Image 32

Contents DC-190 Introduction Repacking DC-190 Scale Capacities and ResolutionsUnpacking and Inspection Other S-Series Remote Platforms Scale no DC-190 ConsoleUW/1000 Pcs 2 DC-190 Keypad Locking and Unlocking InstallationSetting Up Powering Up the DC-190 Location of AC Power Cord Receptacle Load Cell CableSetting Time and Date Location of Top Cover ScrewsInstalling Cable Strain Relief Pole Mounting InstructionsSpec Scale SetupScale Conﬁgurations Spec SPEC17 APW Customer Speciﬁcation 141 SettingsSwitching if Spec 2, bit 1 is set DIN-8 Force Balance 010 Weight and Measurement Speciﬁcations 142 Settings Connector, select SpecSpec Min Max Selecting 1 can damageLoad Cell Sensitivity Selection mV/V-PORT 2, Scale 2 or Max Spec MinRS-232 Speciﬁcations 143 Settings Not used set toEntering Tare Weights Scale OperationsToggle Between Scales Toggling Between Net and Gross WeightEntering Unit Weights Unit Weight Operation by Key Entry Other Operations Scale Programming Item Code StorageItem Code Maintenance Using Item Code in Normal Mode Re-Computing Item Code Unit Weight Procedure Connector Pinouts Pin DIN FemaleDC-190 Messages Clearing Locked-Up Scale 888888 Error 10.11 DC-190 Ultra Count Speciﬁcations DC-190 Ultra Count Limited Warranty